RC speedboat - Self made
Uploader Comments (tommy4421)
Top Comments
-
duck tape FTW
All Comments (68)
-
@ciukcia989 you should look out for someone that knows how a model boat should be.
dont simply buy a bigger prop, that can overheat your engine!
in the vid, the boat is to slow because it is to heavy in the back. it could be faster if it would stay flat.
-
hoe heet da numer
-
Gewicht weiter nach vorne :)
-
wtf self made it is own made xD
-
line the hull with fiberglass so it doesn't get waterlogged
-
@mooiekip4421 ja ik denk dat je bij deze boot gewoon een zwaardere romp nodig hebt want ik denk dat ie met deze motor echt veel harder kan. je kan bij hobbyking van die lege rompjes bestellen voor ongeveer 30 dollar. en dan kun je er alles in bouwen.
-
@christiaan12nl Ja dat is wel ff moeilijk. Zoals je ziet heb ik ook de accu helemaal van voor in de boot gezet. Maar het is nog niet genoeg. De voorkant van de boot word nog teveel naar boven getrokken. Wat je eventueel nog zou kunnen proberen is om as meer verticaal te plaatsen. Zodat de boot niet uit het water word getrokken, en meer naar voren word geduwt.
-
@mooiekip4421 krijg je dan niet heel erg snel te maken dat je te veel contragewicht aan de voorkant hebt ? ik heb hier een oude nikko boot van me broertje waar ik een borstelloze motor in hebt gebouwd. was 3 weken bezig om het contragewicht goed te krijgen xD
my boat goes really slow, it has a powerful engine, but it is still slow.
have any tips to speed it up?
ciukcia989 7 months ago
@ciukcia989 buy a bigger prob
tommy4421 7 months ago
Nice boat is the hull poly?
nitropowerhead107 1 year ago 4
@nitropowerhead107 The hull is made from polystyrene, that was used for isolation.
tommy4421 1 year ago
@nitropowerhead107 apres ski hut - wat zullen we drinken (jumpstyle remix)
tommy4421 1 year ago
Did you make a mechanical speed controller? Or was it simply an on/off servo driven switch?
Because on the inside picture I could see one servo with a linkage coming out to what I'm assuming is for the rudder and then another servo with a small linkage going to a small arm inside the boat. Could you please tell me what you did.
MarshFacev2 1 year ago
Hey MarshFacev2,
Take the switch/trim-pot from a drilling machine ;)
Tom
tommy4421 1 year ago