BT TM Rip Clip installation

I haven't seen any videos yet of the new rip clip so here goes. There were only 2 screws in the box which luckily were for the tm7. The tm15 screws are probably slightly longer. I had one small issue where the front screw would not tighten down and had to use a little extra force to get it in. Overall, it's an easy setup and will make another video testing it out with paint.


***UPDATE***
I called PaintballSolutions and found out it's only 1 set of screws that should fit both tm7 and tm15. Anyone with both markers can verify.

Category:

People & Blogs

Tags:

• bt
• tm
• rip
• clip
• tm7

[GabZelle]

is this still the newest verion of the hopper?

[vinspad0]

@GabZelle

Yes

[willpowers100]

what happens when your rip clip starts blinking red?

[vinspad0]

@willpowers100

Low battery

[Woolies999]

If you have the rip clip attachment on a bt, will a hopper from an a5 / x7 work on it ?

[vinspad0]

@Woolies999

Yes an a5/x7 hopper will fit. Any hopper for cyclone feed will fit. There are multiple variations out there with different sizes and paint capacity. Search " a5 hopper " in Google shopping and you'll see many styles like pinokio, tac cap, offset hopper adapter, etc.

[81ronaldinho]

will it fit the old bt omega

[davidJR]

I had the same problem with the left screw, but with a little force it did catch and stay put nicely.

Great video btw.

[jeremysart]

@vinspad0 Ahh! Thanks for answering, I had the exact question after learning about this feed system. This is a great alternative to installing a Cyclone feed system on the 98 Custom, as this is interchangable. Once you install Cyclon however, there is no simply going back.

[rauleeter]

@vinspad0 I just installed one on my a5..the bt 4 ripclip isnt the best fit..i recommend the tm series as i have a hopper now that does not seem to be the proper fit even though the flasc adapter label said both bt 4 and tm series would work. That does not seem to be the case.