how to draw the threads on a screw

this will show you how to draw the threads on a screw and these steps can be follow to draw the threads on the nut. Hope you guys like it and feel free to comment.

Category:

Education

Tags:

• Catia

[schliessmanj]

thanks for uploading this, it helped me a lot with a school project

[fredyax7]

@schliessmanj you are welcome and am glad that this video has help you, if you wanna see something else done in catia please ask and I will be more happy to help you.

[eldominicanosindudas]

thank you !!!!!!!!!!!!!!!!!!!!!!

[fredyax7]

@eldominicanosindudas you are welcome and don´t hesitate to ask questions or if you wanna see something done in Catia. good luck

[fantaaastic0]

helllo can you give me your number i have a couple of questions pleassseeee

[81XS11]

Do you have something against standards? Where the heck would you use a 2.674 inch bolt with a 72.04 degree thread? Whitworth is the only one I am aware of that doesn't use 60 degree threads and they use 55. Where does a 2.674 inch bolt come from? is it so you could throw in the 1337 (leet)? because really you aren't. Seriously, you tooke about three times longer than you needed to, and your profile sketch should have had about 18 less constraints.

[bumblebeez06]

EXCELLENT!! Me and a coworker were trying to figure this out just today. It was fairly simple in Pro Engineer and a drawing I did years ago was being redone by this designer do to poor CAD migration a few year ago. Thank you, thank you a thousand times!!!!!!!! I will be watching for more of your videos on CATIA.

[ertejinder171]

really helpful,,,,thanks too mch

[ThePavelscepka]

@fredyax7 I do want more, I am just beginner and I would like to have as many video turorials as possible to go step by step from what I see

[fredyax7]

@CressKayEdge sorry guys for answering this question late since youtube had me to make another acount with google and I already have to many. Well it make sure that your spring is place correctly if you said that the profile is correct try and check the coil

[CressKayEdge]

@fredyax7 I'm having the same problem. I don't find any problems on my constraints though. Care to enlighten me?

[H7TQR3SV]

i think you should use @4:37 a orthogonal plane to the coil to draw the profile of the screw.

On your way the screw has not the right profile.

[tepestepes]

thx very useful