RC Delta Wing Mixing - Combat Flyer

http://www.hoverandsmile.com/combat/93/combat-flyer-delta-wing-mixing for the original article. We go over common mixing methods and programming to help your elevons work properly.

Category:

Entertainment

Tags:

• Delta
• Wing
• Mixing
• foam
• combat
• rc
• airplane
• mach
• one
• flyer

[cafediablo30]

I just got a pk zone stryker and was thinking everything was ok,,..I set it up in my tx(walkera2801 pro) in th delta wing mix and it all seemed ok, till I tried it at th park for th first time,..I pulled back on th stick expecting it to go up up and away and instead it plowed str8 down,lol,..lucky for me it didn't get a chance to build up speed otherwise I would be crying,hah haha,anywhoo, seems their programed mix is wrong so I'll try it ur way,and cross my pinky toes,thanx brother,peace.

[erkrystof]

@cafediablo30 Hope it works out for you, just watch the control surfaces and make sure they match up to the video! Good luck!

[Gofer303]

Thanks for the info could have read a really thick manual with out understanding. keep up the good info.

[erkrystof]

@Gofer303 Much appreciated, Gofer, glad it helped.

[herrhazl]

Hi I have a delta wing with an additional canard operation requirement. It will be a J-10 fighter.

Can someone help me with the setup? I have the left wing servo hooked to the aileron port and the right wing servo hooked to the elevator port.

So far I have my canard hooked to the elevator port via y-connector.  is this correct?

Please help..im using the walkera 2801 pro tx and rx combo.

thanks pilots

regards

[ritagauci1]

Hi From Where I Can Buy That Wire ? Because i don't have good tx like the dx7 etc.. Thanks Wayne

[tunicfly]

Hi, Thanks for the info.It was very helpful.

Luckily I have a DX7 .., :)

[shadav21]

Dude u r the best instructor

[christinano1]

Great video ! I have a Futaba 10c. Do I need to connect each aileron servo in his own channel. Or should they just be connected with a Y harnas in one channel?

Thanks

[erkrystof]

@mickvk You're looking for the term 'breadboard'. There are many types available, some with contacts to wrap wires around for power input, some simple little boards that you supply input power with your own wires. Regardless, that's the term you should use. They're great for prototyping before you solder anything together.

[mickvk]

@erkrystof Yes. But at first it didn't work because I wasn't using the right channels. Then I tried manual mixing, couldn't get it. Then I finally got Delta Mixing to work properly. Maiden flight scheduled for tomorrow!

I have a question if you don't mind; in one of your LED how-to videos you use a circuit patch board that I think you called a bread box?? I could really use one of those but can't find it. Can't you give me the right search term? Thanks.