Bow Tuning Tip/ Tubeless Peep Installation
Uploader Comments (grttaxi)
All Comments (51)
-
Hello, Thank you for your advice. they really help me . I shot over 500 arrows with my bow and the string is still running. Is it the fault of the quality of these string ? (PSE NOVA 2011)
-
@grttaxi hey how do i install a tri slot peep? and my string is one single string?
-
Awesome vid as always!!! Wish I would have seen this a couple weeks ago when I replaced my peep sight. Keep up the great work!
-
@grttaxi thanks, i´ll wait to the end of the hollydays to ask you for this item and others. thanks!!!
-
I have seen a few of your videos and I like them all your very helpful in explaining every step
-
@DRA5136 I had a peep site that was separated in thirds like you say yours will e and dint like it, every now and then I would draw back and have a string in my way people would say just keep turning it and the sting would get trained ,but I had no luck so I went to the tube one and have good luck only problem I have notice with them i the rubber tube will brake so have to change them out every year or so
-
i have a peep sight with the tube on my bear archery strike and when i shoot, the tube hits my bow string and effects my shot because the string ends up outside of my top supressor. if i get a peep sight like the one from this video would it fix my problem?
-
@Astrorage Because they were practice arrows. just like spear fishing they are not needed.
Great video!!! I´m from Brasil, and even with my bad english I´d anderstanded each word you sayed, thanks!!! the only problem is, that we have trouble even to put our hands on a string like the one you used. (hard to find) by!!!
niltonelite 2 months ago
@niltonelite look on my website, I ship to Brazil world wide shipping available my friend.
grttaxi 2 months ago
where did you get that seperator??
Lippa100 9 months ago in playlist Bow Tuning Tips
@Lippa100 from bowtuningtips my website has them listed along with the other tools for bow tuning
grttaxi 9 months ago
I have a peep with the tubing and would like to go to a none tubing. I have one that requires the string to be separated in thirds, is there a way to do that similer to what you are doing with your string spliter or do I need a bow press?
Thanks for the videos
DRA5136 1 year ago
@DRA5136 You do it the same way you just have to split the string more times is all. It may be easier to use 2 string seperators instead of one.
grttaxi 1 year ago