Scarecrow does battle with the Generator - Part 2 of 3

Last video made it look pretty easy to get a certain cheap Chinese generator with a 3.5 hp engine to run on HHO.

This time, thought I would let you see all "out takes" so it ended up being a "Trilogy".

The Engine is an 85cc 3.5hp 4-stroke similar to a Honda design.

The Generator is rated at 1200w wtih 1500w peak

The electrolyser is power off a wall outlet and is drawing 120vAC at 15a. Voltage to the electrolyser is 150vDC at 14 amps. Gas output is approximately 10.5 LPM.

In this video, I am trying to get the engine on the generator to at least run by feeding it a volume of HHO that might be able to be produced by my electrolyser. So energy to the electrolyser was held to the 800-1200 watt range. It seems the engine is able to idle on the HHO that I can produce with 1000 watts.

http://www.energybuilders.net

Category:

Science & Technology

Tags:

• HHO
• HOH
• Browns
• Gas
• Electrolysis
• Water
• Fuel
• Hydrogen
• diy
• gadget
• Hydroxy
• OxyHydrogen
• EBN
• Energy
• Builders
• Network

[amos033]

A better idea would be to find out how long the generator runs on a fixed amount of gasoline compared with the same amount of gasoline + HHO. It would prove to all

once and for all if HHO can give more mpgs by measuring the run times with and without HHO. What say ye?

[SmartScarecrow]

@amos033 - there were folks working on that at the time I was doing these experiments - my experiments were focused on defining the characteristics of a small engine run on 100% HHO - there is no gasoline being fed this engine - it is running on HHO only - I was able to define optimal HHO:AIR mixes and noted performance characteristics of an unmodified gasoline engine - I'm just one guy - time to hand off the torch to someone else

[liplokker]

need to change timming to after t d c to make it run right valve is not closeing in time for spark when it ideals up

[SmartScarecrow]

@liplokker - purpose of these initial tests was to see how far I could get with little or no modifications to the engine ... see the playlist of collaboration between D3adp001 and myself for more advanced experiments and full report of data and conclusions ...

[vid009]

SmartScarecrow, have you done any mods to the engine or Genset itself?

[SmartScarecrow]

@vid009 - in the experiments shown here on YouTube, no ... the only mod made was the installation of 1/4 push on tube fitting in the plastic spacer behind the carburetor ... this is where the HHO was introduced to run the engine ...

in later experiments, a number of mods were made and methods employed that could be rather dangerous to try to replicate ... after I lot of soul searching, I decided not to make these public but have discussed with other active experimenters who have replicated ...

[MaleTestosterone]

where is the bird battling the engine?



[buckstarchaser]

I think this shows the importance of not mixing your fuel with its oxidizer until it's in the combustion chamber. If electrolyzed water is ever going to be safe for practical use its constituent components need to be separated from one another.

[liplokker]

@SmartScarecrow im poor i cant aford to make a cantainer for mine i found a scrap door for my staneless steal it was free or id not have any to play with

[liplokker]

@SmartScarecrow i dont have much money ether im looking at a propane mixer about a 50 would run a gen.. 50 75 dollars

[liplokker]

sorry about that i ment after top dead center other guys are trying to run them on it and thay are changing timming i say it will run on it i dont know it should not work im looking for a l p g  mixer to run my car on hho ...... my self im going with more cells with a lower amps to perduce it that will help with the heat issue too