Changing out a crossover and a dj tip with subs
Uploader Comments (RockTheHouse4)
All Comments (23)
-
@iceman977th the amp uses both channels and combines both channels and outputs them to a single output. (bridge mono)
-
@RockTheHouse4 I meant as to why you were getting signal on both channels with one input
-
@iceman977th you got it, Bridge mono on the amplifier, both channels combined and driven at 4 ohms when both 8 ohm speakers linked in parallel.
-
@RockTheHouse4 Parallel mode maybe?
-
try using replacement 1/4 jacksto block the hole that look like a L shape thay are flat looking and vary cheap to get for a pair that worked for me for my jbl 18inch subwoofers that have in or out 1/4 jacks i use the speakons on my jbl and i run my crown amps with a dbx driverack yes this work with any thing that has a lot of bass
-
@kyle2284 You mean you have 60 Xti ams altogether? Wow, unimaginable! That must drive several sets of JBL Vr speakers man!
-
if your amp was bridge and you just have 1 amp. why do you need a crossover.. a crossover is to cross frequency (hi,mid,low)... do you have subs??? if so you can't run a 1/4 speaker cable from it 2 your tops... you would need a 4 pin speakon cable... and 2 amps or both ch of your amp (not in bridge mono)
-
@FlatulEssence (24) Xti 2000's for my fullrange cabs and (36) Xti 4000's for my subs. I have a touring sound company
-
@kyle2284 which xti amp do you have?



nice video. can u tell me how hook a crossover with the amp?
juancs1813 1 year ago
@juancs1813 most subwoofers have a built in cross-over. the amp may have a cross-over for subwoofers only that can be found in the manual of your amplifier.
RockTheHouse4 1 year ago