Superior Metalworking with Low Foaming TRIM MicroSol 585XT

Greetings, this is Mark Scherer, from Master Chemical Corporation, with a visual demonstration of how we significantly improved the low foaming characteristics of one of our TRIM® cutting fluids.

On the left is TRIM® MicroSol® 585, while on the right is our new TRIM® MicroSol® 585XT, an extended-life, nonchlorinated semisynthetic metalworking fluid.

Both products are mixed using a standard kitchen mixer and at exactly five minutes the mixer is stopped. Notice how quickly the foam completely dissipates from our new MicroSol 585XT. It only takes seven seconds, compared to fourteen seconds for the original MicroSol 585.

For more information about MicroSol 585XT and other cutting fluids, please visit our website www.masterchemical.com.

Category:

Education

Tags:

• foam
• metalworking
• synthetic
• semisynthetic
• MicroSol
• TRIM
• Master Chemical
• Mark W. Scherer

[vacone1]

Nice video. However one must consider the air injected into the system around the shaft seal of a large centrifugal pump. D. Els