Simplified Router Fence Setup

George Vondriska provides an easy way to set up your router fence. A WoodWorkers Guild of America (WWGOA) original video.

Visit http://www.wwgoa.com/ for more woodworking videos!

Category:

Howto & Style

Tags:

• Woodworkers Guild
• woodworking
• woodworkers
• wood
• george vondriska
• lock miter
• router

[datzfast]

coulnt you just use pre cut scraps to dial in the fence abd bit height?

[wwgoaeditor]

@datzfast Yes, you could. The jig just makes it a lot easier.

[darkneolord]

those 2 PRAZI jigs are worth $200 for both of them, even though I like your videos I found this one, not so helpful, it almost looks like an infomercial for PRAZI, I'm pretty sure this jigs are worth their money, however $200+tx, is too much, just my 2cents

[2Phast4Rocket]

That looks too complicated for my shop.

[egastap]

George, really like your videos. However, firstly the joint you showed at 5:37 is actually not very good at all....there's quite a gap on the outside corner. Secondly, I didn't find it that 'easy' to understand the set-up....now maybe that's me, and thirdly, can't imagine buying these set-up tools to do what......use it maybe once or twice a year?

Sorry George, this piece of wood goes in the scrap bin

[mrpaynee]

0:01

[mrpaynee]

0:00

[dubsaloon]

Using the V-bit would also get it done. Most folks are not going to buy the fancy tool for such limited use as getting tools to get the work done would take priority. Just my 1/2 cent. Liked the video.