Part 5 Build a Putt Putt Pop Pop Steam Boat s2 cut middle can

Part 5 is Step 2, cutting and trimming the middle part of the can so you have a sheet of aluminum to build the engine with.

You can find more DIY science projects like this at http://www.sciencetoymaker.org/

Category:

Science & Technology

Tags:

• pop pop
• putt putt
• steam engine
• boat
• build
• make

[nyomcat]

i cant find part six seven eight nine ten eleven and twelve

[sciencetoymaker]

@nyomcat I can't link in comments, but go to sciencetoymaker org and there's a page with the links to all the parts.

Slater

[southparkporsche]

My Pepsi can doesn't have a line. Is there a measurement I could cut to instead?

[sciencetoymaker]

@southparkporsche Then just trim off the jagged edge. This is not the final cut. When you cut to the pattern, it's narrower. So trimming the jagged edge does not have to be an exact cut.

Slater

[blaze555660555660]

@southparkporsche it said use it as a guide, and that you could experiment with it later, therfor there is no exact measurement . i hope i answered your question a year later.

[XxMeTFieldxX]

Following tutorial... thank you very much!

[sciencetoymaker]

You can find links to all the videos at sciencetoymakerDOTorg (I can't put URLs here in the comments part).

Slater

[grantika445]

can u help me find the beginning of the tutorial i cant find it :(

[MJanddaftpunkfan25]

thank god i found it this im amking a daft punk helmet and i need the bottom of the cans for the ears and ive been cuting the can wid a knife and it gave a real shark jaged edges but how did i not thing of this in the first plaace lol

[sciencetoymaker]

I have hear that if it's one of those new steel beverage cans without ridges, it will work. However, it is harder bend.

Slater