BURT RUTAN LONG EZ - BY RICHMODELS - PETER

A COMPILATION OF CLIPS OF PETE FLYING HIS RICHMODEL / WHOLESALE MODELS LONG EZ RC MODEL AIRCRAFT DOWN AT THE PATCH ON SEVERAL OCCASIONS . POWERED BY AN OS FS 70 SURPASS II TURNING A 13X6 WOODEN PUSHER PROP. PHOTOS AND VIDEO BY MY 14 YR OLD SON DEAN .

Category:

Entertainment

Tags:

• burt
• rutan
• long
• ez
• ic
• rc
• radio
• controlled
• models
• aircraft
• airplane
• aeroplane
• fs
• fourstroke
• internel
• combustion
• engine
• jet
• piston
• glow
• motor
• radial
• uk
• england
• europe
• ali
• machinski
• dave
• stevens
• lma
• large
• model
• association
• warbirds
• scale
• giantscale
• big
• remote
• control
• flying
• flight
• flywings
• great
• war
• united
• kingdom
• british
• britain
• nitro
• planes
• ww1
• ww2
• fast
• video
• digital
• movie
• camcorder
• flycam
• one

[Guinnie]

Thanks for the input...I just read your posts at my You tube page The glue did not hold on the metal bit so I just mounted a servo in the front side of the plane, should be strong enough I am going to add some more nose weight like you said and hopefully the ladings will all be greased right in

Thanks for the advice

[tbobborap1]

@Guinnie glad you sorted the cannard out , hope all goes well , like i said once she is set up properly she flies like shes on rails , let me know how you get on when test flying her will you , hope all goes well - pete .

[Guinnie]

where did you buy this? I could not find Wholesale Models?

[tbobborap1]

@Guinnie wholesale went under theyre now called ashford models , dont know if they still sell em , give em a ring , i saw a new boxed one this week on bmfa classifieds = ave a look .

[Guinnie]

@tbobborap1 Ahhh I found one Gunna do it Electric Can you give any recommendations as far as the throws are concerned?

The manual is laughable

Thanks

[tbobborap1]

@Guinnie hi , wrote mine off back in may so cant measure them but i think the elevons were about 15 mm up and down , the cannard was about 20 mm down and 15 mm up , dont forget when u pull the elevator stick down to make the model go upwards the cannard must go downwards to raise the nose! happy landings - pete .

[stealhty1]

@dubucman thanks

[stealhty1]

may i ask how far did you set your CG location from leading edge ?

[Guinnie]

did you fly yours on 2.4 or FM? I am having some issues with interference

I think I might have to change the roting on my antenna

[Guinnie]

@tbobborap1 Thanks that helps What happened to yours?

Did you have any trouble with the metal joiner for the canard? I just glued the the thing in and it seemed Ok then I went to set up the servo on it and that center part that comes down had broken free of the shaft..

I cut a hole in the nose top and put some epoxy on it so I hopefully I fixed it