ABS Sensor Diagnostics, Troubleshooting and Repair
Loading...
181,511
Loading...
Uploader Comments (markjhicks)
see all
All Comments (115)
-
Sorry.I did get about 14.4 volts on both sides after a better meter.It's a brand new hub assembly!!:(Could it really be the fault even tho it ohms out ok?
-
Ok.No dc volts at either side connecters?Already checked fuses on passenger compartment.
-
@jasonlongor1 I am not sure what the DCV is, but I do believe the harness goes up on the drivers side to the controller. Remember you want to be checking the left side (Drivers).
Mark Hicks
Wells Vehicle Electronics
-
Haven't checked yet,but that would be dcv in passenger side harness to the the vehicle correct?
Loading...
i had same situation, but in 2001 cavalier z24.is it same procedure?
mod3lstud 2 weeks ago
@mod3lstud Procedure is the same for most every vehicle with a few exceptions like a Nissan for example. But the pin-out to the computer is different for every vehicle.
Mark Hicks
Wells Vehicle Electronics
markjhicks 2 weeks ago
Checked ac volts to wheel while driving.None shown.Put old one back on everything fixed.Order replacement.Thank you so much for your knowledge and time!!
jasonlongor1 2 weeks ago
@jasonlongor1 You are very welcome. I am happy you diagnosed it! You an opinion in the future, you have my number.
Mark Hicks
Wells Vehicle Electronics
markjhicks 2 weeks ago
@markjhicks I was referring to a dc voltage.So drivers side ohms out going down,now check the voltage going up,correct and it should be 9 volts?Thank you again!
jasonlongor1 3 weeks ago
@jasonlongor1 Correct.
Mark Hicks
Wells Vehicle Electronics
markjhicks 3 weeks ago