ofna ultra lx one start

not being run for a week engine 1 month old

Category:

Education

Tags:

• ultra
• lx
• rc

[norco1606]

@GOT911BOOST that's how i do it. But there is no gas going to the carb i think, but when i unplug the wire from the carb and pull there is gas coming off. Could the carb just be blocked or something? And what can i do?

And the glow igniter is fine...

[GOT911BOOST]

@norco1606 like everyone is saying too, just put yur finger over the exhaust outlet, and give it a few pulls until u see the fuel travel to the carb, then just put yur glow igniter, and give it a few pulls and should start right up, awsome engine, so if it doesnt start right away, either bad glow plug, or it needs tunning! mine starts on the dime!

[norco1606]

@GOT911BOOST how do you prime it?

[Mrpinoyboy711]

What a noob ;(

[GOT911BOOST]

wow, uhh ive had my lx1 sitting for more than 2 weeks, and it only takes my about 15 pulls to start it, but 3 minutes??? prime it maybe??

[AuzzieHobbies]

Put Finger over exhaust pull until you see fuel go into the carbie give 3 more pulls after that. put in glow igniter and pull until starts. Should only take about 5 pulls to get it started after that, let your nitro car run, just idling for 3 mins then you can use it. This method will give you great engine life and will make your engine smoother.

Another Great Tip From Auzzie Hobbies

[jamen155]

You are a dumb ass I can start my lx one in 15 pulls or less

[predxene]

.......just keep pulling it... it may actually start...

[SuperCrazyspade]

im suprised he even new he had to put nitro in it. lol

[BenMale1]

No, he just didn't have the throttle trim up enough, or at all for that matter. Cause it was farting which means its primed.