acme condor pro stock

this was when i just got my buggy and didnt upgrade it much, it had a 18 GO engine in it. i found it realy hard to tune so i scraped it

Category:

Entertainment

Tags:

• nitro
• RC
• buggy
• condor
• GO
• 18
• engine
• acme
• pro

[spudhead175]

i cant get myn started! i've tried everything that nitrotek suggests but it still wont start, it has started twice in the 10 dayas that i have had it. can anyone help me?? i have primed the engine.. avoided flooding the engine etc but still barely any response.,

[RCnitroracer123]

ok a few things to check it the glow plug and starter, the cylinder head and exhauset maifold is on properly u idle isnt to low and perhaps the clutch and springs all of these will make an engine hard or impossible to start

[spudhead175]

thanks for the help anyways but i got it started good now!. urm another thing though... can you give me any advice on how to alter the brakes? i came dangerously close to clipping a rather nice bentley today!

[RCnitroracer123]

theres a couple of ways to do that, 1 is to slighley tighten the 2 screws that hold the braks to the gear gox. 2 ur can adjust the brake arm nd lever or u could play about with the servo, just be sure to test it again befor you drive it lol hope that helped

[lahbl]

Mine came with the sleeve in the wrong way.

[EckoMusicman]

try the tuner just under the air filter dont mess wid it to much or youl throw it right off

[dustinjwco04]

hey i have a condor pro where did u get your upgraded parts for it at?

[elbob099]

yeah thanks for the reply, i had that problem a while back and glued them for a better hold, the problem must be with the diffs or summet, should be a good late night project love seeing how things work :->

[ledwardz07]

hey u have had the same problem as me just woundering if u got it sourted did u get it to go full throtle ? myn dosent

[ledwardz07]

hey do you know whether or not starter boxes can be used with this car am wantin a one as im sick of pulling my fingers off starting it

[ledwardz07]

hey i know ur problem my car also does it oftern u know the duffs check the props what come off them the fat thing should have tight grub screws in if the grub screws ar lose you dont get 100% power out of it please reply if this isnt clear engough to help

[elbob099]

i have one and it dosnt get drve to all wheels the front right is the strongest and front and rear left can free wheel when i spin the wheel and the rear right works a bit. should i take the blasted thing apart and rebuild. need to get it on the snow if we have any this year XD

[tlaroche38]

1)Take off the cover,and look for the little star shaped throtle and brake lever and check the position of the rods.2)Tune it on the remote.3)Get a screw driver(flat headed)and make shure the fule mxture isn't set to rich. if it is,set it to normal.4)Contact Kev's racing bits for futher assistance.

[bebokosmoko]

hi all I bout a new ACME Condor pro nitro buggy .18 engine when i start it takes off and when i push the brake it shuts off can anybody tell me why is doing that