Roller Rockers while motor running

Just thought I would show this while checking for issues. Roller rockers have been chattering too much :(

Category:

Autos & Vehicles

Tags:

• pedestal
• mount
• adjustable
• roller
• rockers
• ford
• mustang
• 5.0
• 302
• 351w
• chevy
• camaro

[macombsucks]

Dont bash me for asking, but how do you get them to be quieter?

[Xarmy187]

@macombsucks you kinda gotta deal with the noise.

ether stick with stock stuff, and leave horsepower on the table, or you spend big bucks for the high dollar rockers that are quieter.

[macombsucks]

@Xarmy187 oh alright, sweet stang by the way. When are you lookin to the get supercharger on it?

[Xarmy187]

@macombsucks ASAP. should be about a month

[123ewq]

what TB are ya runnin on that with the typhoon?

[Xarmy187]

@123ewq I use to have a typhoon intake, that is a Victor 5.0 intake.

The throttle body is 70mm bbk

[MrWellminded]

@MrWellminded nevermind

[MrWellminded]

is that a hydrolic roller cam or flat?

[bbsombs]

but they will work loose in a good way to the point its in its desired valve lash..like my 347 stroker after warmed up my cam has a valve lash of .026 i set it at .024 just a lil tighter and after i run my motor its at .026 right where it needs too be

[bbsombs]

what type of rockers do u have?? i read that you have been having too reset them alot or so..and yr running hydrolic right? iv always set my rockers just a hair bit tighter than what the cam sheet says too do for hydrolic or solid mainly cuz the rockers are gana work loose regardless and there only going to work so loose unless you dont get the nut on the stud tight enough...