Removing the Stair Nose for Hardwood Installation

The best way I have found to remove sub-floor stair nosings for hardwood or laminate floor installation.

Category:

Education

Tags:

• stair
• step
• wood
• hardwood
• installation
• on
• stairs
• Ken
• Frango
• Arizona
• Floormagic.biz

[shawnspeed3]

I just used your method and sawzhall, but I did use a circular saw first. It may be an extra step, but easier since it cuts smoother (use a new carbide 24T blade). You cut most of the tread after measuring the depth and amount to riser (1-1/2" usually). Then use sawzall to finish each ends by cutting in and towards ends. Using the sawzall to cut ALL the bullnose would be too tiring due to vibrations and effort. At lease circular caw cuts easier and smooth like butter-saving your arm!

[FLOORMAGICbiz]

Whatever works for ya. Circular saw throws a lot of dust.

[insidethe222]

i used this method works good but wht filles the hole on either end that is 2 inches into the sides of the stairs

[FLOORMAGICbiz]

Not sure what you're refering to. Can you elaborate?

[ClicksMcGee]

i laughed at the music =)

[JoeCavy4]

Thanks for the vid

[doggy8kitty]

Nice tutorial. Until I watched this video I had no idea how stairs where covered. I do see someone destroying their wall with a sawzall if they aren't used to handling, specifically at the ends.

[triage1998]

@FLOORMAGICbiz

I have the same problem as insidethe222. I believe his treads are installed from the rear and are inserted into the stringers and not flush against them. Mine treads are at least 1" into the stringers and has a small gap probably caused by the treads shrinking over a period of time (30 years). I am going to try to fill with wood filler, then sand, then paint. If anyone has a better idea I would like to hear it. BTW great tutorial.

[dargis49]

Nice tutorial.

[CJTodd61]

This is just what I was looking for. Thank you so much for your advice with this one