GEETs on F350 01-03-2011 vblog1.wmv

This is the first video of what may become an on going video blog about experimenting with GEETs on my 1990 Ford F-350.

To understand what this is all about, visit the yahoo group:

http://tech.groups.yahoo.com/group/VortexHeatExchanger/

Category:

Science & Technology

Tags:

• GEET
• F-350
• fuel
• reformer
• plasma
• VortexHeatExchanger
• reforming
• Paul
• Pantone

[ryaninwatson]

Looks like a lot of work, hope you get it going! I want to figure out how Stanley Meyers made his hydrogen injectors, they are amazing! check him out if you have time.

[narivasant]

@ryaninwatson

Yes, a few years ago I studied Stanley Meyers work and Yul Brown for years and the Joe cell also. I wasn't able to see it but I heard Yul Brown made some specially conditioned water shown on national news where radioactive material was immersed in the water and it lost its radioactivity. The Geiger counter just started dropping way down. I hope you get Stanley's design working.

[sirHOAX]

still feel the need for these geet devices maybe in the design of the header that comes straight off the engine block. and any vacuum that would be needed would have a turbo charger to pull the right amount through the separate chambers that came off the header/bubblers. glad to see people still building. keep up the nice work. cool project vehicle the same.

[ehnriko]

Kudos! :-)

[Rawbush]

You might have better luck using ideas from the hho boosters electronics, like the map sensor efie and the O2 efie. These devices take the original signal going to the ecu and modifies it. This causes the computer to some what lean out to a point. Very nice build will be watching for future videos. Peace rawbush

[uawwildbob]

ya might wanna try an O2 pypass circuit. the geet gas burns much cleaner and the sensers will detect it