different spin on the hho dry cell

this cell was derived to answer some of the in stall problems i was having on smaller tighter confined areas. This cell funnels gas into corner without having to be plumb or square in vehicle. I do not use pumps in my system to keep expense down. the cell will self pump with at least an 8" vertical difference between it and reservoir. Other designes are also being tested. the diamond will be avail within the week. Will post final numbers and results.

Thanks for the views and subscriptions. Just get out there and do it!!!

Category:

Science & Technology

Tags:

• drycell
• hho
• hydroxy
• hydrogen

[advancedhydrogen]

hey rob! i want one of your pwm's.. and good job on the new dry cell. i tried the bolt through the plate design on the 4x4 van it works great! later bro... be blessed scott

[higherpoweredh2o]

Not using pwm at this point. Effective cooling is much more reliable than a pwm. I am developing one that will soon be released. It is gonna be needed for cold weather. But right now my water never exceeds 130 deg, no pump, no pwm, running at 45 amps!!!!! cooling is the answer my friend. The less electronics there are the less failure there is.

[epicswede]

Way to go Rob! Thanks for all that you have done so far! I'm a newbie but you inspire me and I'm getting a lot of good info from you. You are one of the best sources for good information in this area.

[higherpoweredh2o]

thank you. I am trying very hard too keep it real. there is some other good info. check out my subscriptions and favorites.

[pinoykunat]

Excellent! I'll wait for your store @E-Bay. Thanks

[higherpoweredh2o]

thanks watch vid for links to my production manager store and distributor. I am not selling now due to takes time from research. thanks for comment

[crazybiker420]

I would like you buy a genorator off you, you should email me your prices at eriklucas420@yahoo.ca

[NOBOX7]

try leafing the plats longer then the gasket

so as to double as cooling finns

i have tried this and it dose make a differance

[bhelpurii]

I second that, well done.

[superbee1970]

Hi, Was wondering if you were selling just the plates? What gauge? and what sizes? and how much? Thanks, Superbee1970

[milacute04]

how much are you selling the pwm by it self? my number is 2099813903, thanks.

[djabby]

Rob, why don't you believe in EIFI's? Care to explain?