LED Tube Light Bulb Installation UTube LED Lighting

Today LED Tube bulb T8 retrofits are becoming the forefront of fluorescent retrofit lighting. Unlike fluorescent lamps, LED Tube linear Bulbs always require a small driver to regulate the flow of DC power through the lamp. However, a LED bulb converts electrical power into useful light more effectively than a fluorescent lamp could. Retrofit any current fluorescent T8, T10 or T12 bulb you currently have over to an energy efficient LED Tube bulb in no time at all! Lower energy cost helps offset the higher initial cost of the LED light bulb. Many T8 tube bulbs can be found in large commercial or school buildings and the LED tube model is now being used as the energy-saving alternative to mercury filled fluorescent lamps models currently. Compared with fluorescent uTube bulbs, LED U-Bulbs use less power for the same amount of light, last up to 3 times longer, stop potential fluorescent headaches, contain no toxic mercury, and use no ballast that can fail and also generates high heat levels demanding more air conditioning for a room.

Category:

Howto & Style

Tags:

• led
• tube
• bulb
• light
• lighting
• retrofit
• fluorescent
• commercial
• energy
• green
• utube

[newteknj1]

do you have an email I may send to.

[LEDuBulbs]

@newteknj1 Sure... rick at iedubulbs. com Thanks!

[biglight9]

great video!

[force311999]

@ledasled no the pins on the lamp have no power they only hold them in place the lamps plug in to the driver with wires

[force311999]

I like that you don't need to wire to the old sockets they only serve to hold the lamp in place

saves a lot of time but will only work with lamps that are the same brand????

[Plumlau]

LED tube is inside driver,so it don't need ballast or starter any more.Just make sure there have power in the two side of tube,than the LED tube will work.Also,we know,it is free to change LED tube in Japn,the goverment will pay the money,but if need to hire some labor to remove the ballast and starter.So LED tube--don't need to remove ballast and starter came out.If is up to your fixture.If it is new project,normal LED TUBE good.I stay in factory do LED tube for some time,anyquestion,contactme

[olitetrade]

@ledasled One end driver can be changed in to two end driver are have been used widely ,the only thing you need to do is remove the ballast and connect to the input voltage directly,and it's more easy for the G13 end cap to operate!

[ledasled]

these tubes poss great danger since one end is live when you have one side pluged into the socket. Right now, the one end driver is populous.

[Iseekoutthetruth]

where can you get these led lights?