hho 17 Plate mini stack infamous electrolizer

Introducing our 17 Plate Mini Stack Infamous HHO Electrolyzer.

This electrolyzer is one of our newest patent pending designs. The electrolyzer itself is made of precision waterjet cut 304 stainless steel. Using our high performance plate treatment which increases surface area and all stainless steel connections, this unit has very high HHO production while pulling low amperage. This unit runs at 12 -13 vdc and draws 9 to 10 amps depending on electrolyzer mixture. (Distilled water and baking soda). Also comes complete with side view water gauge, no need to unscrew the cap!

Containment System Dimensions: Diameter 5 inches, Height 9 inches.

Electrolyzer Plate Dimensions: 2.5" by 4" with 0.125" cell spacing.

Cell Configuration: 17 Plate, -N+N-N+N-N+N-N+N-

This cell runs using neutrals. Neutral plates lower the amperage draw, if amps are too high your cell will overheat.

Whether you are seaking to improve your auto mileage, or just wanting to run your own HHO experiments, we can help!

We offer complete electrolyzer systems, parts, and hardware. We can also fabricate to your specifications!

Some things to consider:

Carriage bolts and a peanut butter jar, or twisted wire in an old pickle jar may products HHO, but not much, and will not increase your auto mileage. These cells are also very dangerous as HHO gases are highly volatile. Mixing glass containers and a lack of understanding can result in injury and/or damage to you or your vehicle.

To effectively increase your mileage you need high HHO production, low production will only get you the equivalent of higher octane with some increased performance, NOT increased mileage.

This is also an excellent cell for the HHO enthusiast to conduct their own experiments!

Our 17 plate electrolyzer is constructed from all stainless steel parts. Our containment system is constructed of schedule 40 ABS with all brass fittings, and stainless electrodes. This insures safety and long lasting performance.


thats it for now
thanks again for taking interest in our work!!

Category:

Science & Technology

Tags:

• hho
• hydrogen
• infamous
• electrolizer
• fuel
• cell
• HHO
• Hydro

[gglobot]

Inox 304 is not the best for an electrode I think... the corrosion might be relatively high. I actualy make some test with this kind of steel and it was a little messy after a few hours. Do you have the same kind of problem ? Now i am ordering 316L (which is one of the most corrosion resistant steel) I will try with it. But what make the system low consumption is the electronic behind, not the electrode by themselves.... so you should show the elec part too...

[2112devin2112]

where can i find a container

[goturtlepoop]

well, nice gas output....but what was the amp draw with that output....the 9.13 was NOT when you were cranking out the best production...I have a cell very much like stan meyers...I can use plain tap water and 5 amps and it will produce the same if not more than yours....check out my cell at goturtlepoop

[eliminategas]

Check out my fan controller that solves the overheating on your HHO cell. Eliminategas(dotcom

[snoozlefroose]

what is it for? what can it do?

[drspoon001]

I'm talking about the 'Patent Pending' in the description.

I'm saying there's no point to patenting any of this. Cause what ever isn't already patented, is going to be turned down or bought out during the patenting process and then you'll have wasted time and money.

When the big companies are ready to make billions off of this type of technology.. they'll do it. Until then there is a more realistic several hundred thousand to be made.

That's what I'm talking about.

[asusreviews]

Good, but you wasting your time + money getting it patiented. Stan meyers was killed for his, do you want that to happen to you?

Looks like its putting out a liter per minute of HHO or so. Have you calculated output yet???

[Scstyle7]

What are you talking about? lol everyone is making them all over the internet. Did you think this was something new? I believe stan meyers patented it to begin with...

[drspoon001]

Good job - Don't bother with patenting, you'll only draw attention to yourself. And not the good time, we're talking military (they always give the final go-ahead to the patent people)

Get it to run a generator off of water and rent them out - that's what I'm up to.. the more who do this, the better.

I'm sorry to say, but if you use the 'regular' means of getting this invention out you will be bought out or snuffed... your impressive progress will be for not. Please share quickly.

[0ddba11s]

Your config of -N+N-N+N-N+N-N+N- is as I am using in my 15 plate system that draws about 7 amps. Our plates are about the same size as well.