Soundcraft Delta 32 Mixer Console repair service noise gain

How to fix a Soundcraft Delta 32 mixer with channels that cut out and have very noisy gain or trim controls

Category:

Science & Technology

Tags:

• Soundcraft
• mixer
• repair
• console
• noise
• service
• sound

[robstorms]

There must be some. Check with some pro sound companies and see who does their gear.

[robstorms]

I would say it is a problem with control settings but the fact that the bad channels are all 8 apart is fishy. Sorry I can't offer any advise. i can't think of a defect that would do that. Make sure it is not operator error. It usually is when I am the operator

[thebola82]

i have a question.. do you knew where i can get a power supply for a dda cs3?? ive been looking everywhere but cant find anything

[robstorms]

sorry but no

[robstorms]

I use Caig DeOxit; the little tiny full strength bottle if I can get to the contacts directly, the spray if I can't. It seems to work fine; other cheaper stuff( maybe even spit) might work as well. I think most of the battle is to get something wet on there to wash off the crud.

[rokuez]

awesome video i'm looking to trade my labor for a delta 200 24-4-2. what do you think they go for now a days?

[robstorms]

Sorry, don't know. I would check Ebay. For a small fee you can check past auctions and sales up to 90 days old. Good luck !

[fm711]

I have a Yamaha MX12/4 stereo mixer. Every other channel (odds numbers) do not work. I was wondering if there is a likely culprit. I am not sure what happened, but someone said that the problem may be related to overloading the insert. It is possible that I tried to use the channel one insert as the input for an acoustic guitar with effects and sent too much power through that channel? Where would I look for a common component that would cause the other channels to fail?

[ObservationAlaska]

where does one find a tech when they live in arizona?!!

[fillyfresh]

Thank you, you are obviously a legend in your own right ;)

Top tips...

[MrNalRam]

You can get soundcraft parts etc from audioguides-n-mods on eBay

[MoonGhostMusic]

I have Soundcraft Ghost 32/ problem with group 2 when I input channel 2/10/18/26

i GET CHANNEL READING SIGNAL AND SIGNAL IS LIT ON GROUP 2 BUT NOT ON

CONTROL ROOM LEFT AND RIGHT SO NO SIGNAL ON RECORDER ? CAN i FIX MYSELF ? NO TECH CLOSE TO ME..THANKS IN ADVANCE.

[SophicMedia]

awesome video, I have a used Soundcraft Spirit LX7 mixer that has the mute light stays or intermittent on when the button is disengaged, please advice on what might cause that. Thanks.

[rainbowsalads]

hi : )

i noticed on each channel at the top by the pre amp pots there are additional toggle/flip type switches , i wonder what they are for?

[cipmars]

It IS a common problem, I've encountered this problem on an LX7 and on a Series2