First run, VQ35DE in 240SX. 350Z motor
Loading...
40,082
Loading...
Uploader Comments (specdracing)
see all
All Comments (13)
-
damn dude i love u.hahaha but really dude im following this build closely.
-
its just runnin funny because shes confused about not havin back pressure
-
man how hard was the wiring ?
-
how long did it take to do? How much did it cost?
Loading...
is your name mickey andrade?
hickboy91 4 years ago
LOL NO, no it isnt. If he has gotten a Z motor to run in a 240 with a stock ECM, give him my props. Its alot of work. Nope, my name is Mark. Later!
specdracing 4 years ago
It was pretty tedious as the wiring came from three different vehicles. The engine harness was 04 350z, the dash harness was 04 G35 and the engine sub harness was from a Quest. It took some time to get everything pinned out correctly. Then there's all the specific things like sensors, programming keys, etc.
specdracing 4 years ago
very nice props 4 that hummm how much did u get the engine for?!?! and where!?!? i really wnana get a vq35 in my kouki s14!!!
-sUNNY d.=
downsun4621 4 years ago
I built the motor. Got if out of a quest van that had hydrolocked. We put the Z pistons in, replaced the bearings and that bent rod and basically rebuilt the whole thing. Changed the manifolds (i had to custom make the exhaust manifolds), and wired in the stock Z ecm, BCM and NATS systems. You can find a VQ from a FWD vehicle for about $500 and convert it to RWD or buy one from a Z for about $1200. Hopefully you have seen the video of this on the street.
specdracing 4 years ago
Thanks for the support everyone! I dont get to work on this car much, about 3 times a month so its going slow. Once I get a video of it on the street, I'll post it, and by that time, my high compression Z motor will be in my S13 coupe. Video of that soon too! Again, thanks for the support!
specdracing 4 years ago