How to replace Harley Davidson fuel filter on Fuel Injected models Part 1
Loading...
8,297
Loading...
Uploader Comments (gmagmanfd)
see all
All Comments (4)
-
Where is part 2?
-
Basically to release the pressure in the fuel rail which is connected to the fuel line you must pull the fuel pump fuse from the fuse block. Then you hit the starter on the bike. While the engine is cranking the fuel rail will release the pressure in the line. Then you can remove the quick connect at the bottom of the fuel tank. A Harley service manual will walk you through the procedure quite nicely.
-
Great video but I have a couple question.
1. Should I drain the fuel tank first?
2. How did you bleed off the high pressure in the fuel line?
Loading...
Drain tank you will end up replacing the high pressure line disconnect pressure line by turning quick connect it will pop off now push back on lightly and it will bleed pressure
gmagmanfd 10 months ago