Kayak Fishing Flush Rod Holder Installation: Episode 13
Loading...
20,158
Uploader Comments (fishyaker)
see all
All Comments (13)
-
@stephane195 you can buy them at walmart too.
-
How'd you put the washers on
-
How did you put the washers on if you can't get access under the kayak that's my problem.
-
Using a hole saw makes the job a lot easier. Its just an oversize drill bit and in every hardware store. Good vid though...
-
I usually use Marine Goop. I have never had adverse reactions with the plastic, but I guess it could happen.
-
Loving the videos- Learning a lot
What kind of glue are you using on your installs....
I'm a little worried about glue reacting with or not sticking to the plastic. I have a pungo.
-
Love this viedo very much. Any other juicy viedo ?
-
Good job. Good vid, but had to use the mute button.
Loading...
were did you buy the rod holders??? and screws?
thx
stephane195 3 years ago
I usually get rod holders at Bass Pro, cut them to the proper legnth, and epoxy plastic plugs over the end. I like to use stainless hardware from and hardware store.
fishyaker 3 years ago
You dont use any of the glue for the screws?
urawayco 3 years ago
Oh yeh, I just ended up cutting that part out to make the clip a little shorter. Good point. Thanks!!!
fishyaker 3 years ago
Wow,
That was very cool. I have wanted to see that done for a while now. Made it look vey simple I hope i will have it that easy when I do my kayak.
respiboy 4 years ago
Thanks!
Just drop me a line if you have any questions. Its really quite easy. You just need to commit to cutting a hole in your yak... That's the stressful part.
Good luck!
John
fishyaker 4 years ago