BSA VICTOR ENDURO FIX
Loading...
Loading...
2:58
How to start a BSA B50MX with one kick, all day.by 441rider7,438 views- 0:47
Brian Nutter's 1966 BSA B44E 441 Victor!by nuttmeg111,775 views
- 3:22
1969 BSA 441 Victor Special by Randy's Cycle Service & Restoration @ rcycle.comby RandysCycleService2,596 views
- 1:21
Motorcycle Rear Wheel Alignment Gaugeby YTMegiddo16,143 views
- 2:36
BSA unit single b44/b50 into '89 RZ350by 441rider594 views
- 0:35
BSA clutch pressure plate run-out check.by britgaskets4,555 views
- 2:03
Boyer electronic ignition becomes taser after many hours use. BSA 441 cafeby 441rider3,595 views
- 1:07
me on my bsa bikeby bsasteve10,046 views
- 0:55
BSA 441 Victor Special 1969 1.aviby barbeenzinc4,898 views
- 3:16
The most worn BSA 441 in service, circa 1998 retroby 441rider771 views
- 0:33
bsa b25by dirtbag12315,349 views
- 0:44
Matchless mx scramble motocross classicby tog209,885 views
- 0:21
Alec and I Rippin' it up!!by ianmarshonline159 views
- 0:13
1970 BSA Victor 441by 47cj2a4,065 views
- 2:40
MOT: Prepare & Pass - Wheel alignmentby DrivenandRidden40,949 views
- 0:08
BSA VICTOR441by roostermc6,236 views
- 2:47
BSA 441 into the woods we go......by 441rider14,893 views
- 2:58
1st tig pass on 441 alloy BSA victor tankby 441rider34,896 views
- 3:52
BSA 441 250 B50 inner case garage inspection, DIY mechanics.by britgaskets7,159 views
- 7:28
trail side flat repair with three goofballs pt 2by leahcimttenneb654 views
Well, here is what I have found out. The rear wheel sits 9/16" off centre and does not line-up with the front by factory design. The engine was developed first and then with wider tires everything was shifted around in order to keep the weight of the bike properly balanced. My frame turns out to be perfectly straight and is an optical illusion with regards to the rear loop under the seat appearing to be off to one side.
ianmarshonline 3 years ago
Have you figured this out yet? The thing is, that wth the QD hub, the brake and sprocket are all on the outside of the hub--outside the plane of the hub/wheel, tire--thus, the space on left side, between the shock and the wheel, is necessarily wider to accommodate the brake/sprocket assy. I have a 69 VS in my livingroom, and I just checked it--it is about the same as yours. As you point out, the center of the rear wheel must line up with the center of the front wheel--that is what is important.
themightyharrison 3 years ago
Hey steve, it' Ian. We were at the Gastown show with our bikes side by side. I'll give you a call today.
ianmarshonline 4 years ago
I would assemble the speedo drive and spacer and snug the wheel up more, check engine spacer placement, the adjustment rings in place etc. I'll try and get a shot up of my '69 the same frame.
S
britgaskets 4 years ago