Tamiya high lift F350 winch test.

Got the winch mounted,with no stock bumper but im working on a slider front and back set.Ended up breaking my front axle housing near the right steering knuckle,was unknown until it got bad enough to pop out more then stay in.

Category:

Entertainment

Tags:

• tamiya
• F350
• highlift
• winch
• test

[airsoft948]

do you have an idea were a can get a ford f150 f 250 f 350 for a 1/18 scale plz awensor

[Mikel1871]

@airsoft948 For a 1/8 scale I have no idea.May have to custom build that one,Not too long ago New Bright put out a few bodies that were close to 1/8 scale.

[Harvz78]

Cool truck! I just got mine. What tire and size is that and what upgrade did you do? The stock leaf springs are very stiff.

[Mikel1871]

@Harvz78 there a set of RC4WD Rock Creepers(just about 1/2" larger then stock size) also I am using the Red Supersoft Springs from RC4WD and the smallest stock helper.The stock springs will soften up some but I had trouble with running larger tires with them.

[Mikel1871]

No, I'm doing the shooting the camera is mounted on my Transmitter(radio).I took it off for the 2nd half of the video.

[Mikel1871]

Skipped out on getting the renegade axles(a little bulky)so i ordered the yota axles from RC4WD.Waiting on jun-fac drive shafts to get here so i can run it again.

[airsoft948]

where can i get a ford body for a mini crawler losi

[Mikel1871]

Hill wasnt all that steep but i was looking for large rocks.Needed a place to show the power of the winch so i had to get it stuck bad enough to have it pull even under power of the wheels.got it highcentered bad enough to pull the stump loose that i used fora winch point.