Mike's Tips - Dynamic Blocks - Creating A Door Block Part 3 (Flip From Mid Point)

We've been learning about dynamic blocks in the last few lessons and in the process, we've been creating a very useful door symbol. At this point, we have a door symbol that allows us to stretch it to different lengths and the flip the swing of the door about the hinge line. The only problem is that we usually want to flip our door without moving the opening. This week's challenge is to adjust your dynamic door block to allow you to accomplish this. Make sure to test you block see if it flips properly if you change the width of the door.

Find out more:

http://www.autocad2010.com/en/mikes_tips.html?t=40#tip


FR : http://www.autocad2010.fr/mike_astuces.html?t=40#tip
ES: http://www.autocad2010.es/mike_consejos.html?t=40#tip
PT: http://www.autocad2010.com/pt/mike_dica.html?t=40#tip
IT: http://www.autocad2010.com/it/mike_consiglio.html?t=40#tip
DE: http://www.autocad2010.com/de/mikes_tipps.html?t=40#tip
PL: http://www.autocad2010.com/pl/porady_mikea.html?t=40#tip
UK : http://www.autocad2010.com/uk/mikes_tips.html?t=40#tip

Category:

Science & Technology

Tags:

• AutoCAD
• 2010
• AutoCAD 2010
• Autodesk
• Mike's tips
• astuces
• consigli
• dica
• consejos
• Dynamic Blocks

[unitim]

Where is part 1?..