Kenne Bell supercharged Mustang GT

Kenne Bell supercharged @10psi, magnaflow catback/bassani x pipe, 3.73 gears, C&L cai, summitt 75mm throttle body, lightning maf, lowering springs, upper/lower control arms, subframe connector, etc, etc.....

Category:

People & Blogs

Tags:

• kenne
• bell
• mustang
• gt
• 04

[misweetrenvege]

fu(kin love it dude. i got a 97 gt and when i rebuild it i was gonna put forged pistons in and set it up for about 12 psi on a kennebell

[04kbgt]

@misweetrenvege If you build it up and have the PI swap done you could run the 2.6 kit, but the 2.1 at 12psi will be a hell of a start too.

[TheMultimacdrizzle]

@04kbgt sup bro Nice car, Do you think its rare to find anymore mustangs out their in the world to buy such as this? not too rare, but rare?

[04kbgt]

@TheMultimacdrizzle Im sure if you looked hard enough you would find a supercharged GT that is this clean, but be careful buying modded cars cuz more than likely someone ran the hell outa it and had a lot of fun with it. 

[SVTpowerr]

hey bro i was thinking about getting the catless bassani x for my mustang as well and i was wondering how bad the smell is? or have you even noticed a difference?

[04kbgt]

@SVTpowerr Well I have the catted x pipe and it does have a smell to it but its not overwhelming. I do know without cats the smell is worse.

[04kbgt]

I say around b/c before the headers I pulled 420rwhp on the dyno, bout a year ago we added shorty headers (10-15hp) but havent had it ont he dyno since so Im GUESSING its AROUND 430rwhp, maybe even more. You say its impossible? Do your research, Im not the only KBGT with these numbers. The car made 250rwhp before the blower, which is supposed to add about 160hp witht he 9psi kit,and IM runnin a lil more, you do the math. Thanks for the views and comments, just dont like being called a liar.

[disneyprofessional]

@guyd37 if you had done your research you would see that numbers like these with a 10psi kb kit are common if not expected. With stock internals, and nothing more than the 10psi kit itself it should push a little over 400rwhp, add a few bolt ons: throttle body, plenum, MAF and tweak the tune you're sitting in @ about 430rwhp, 500+ to the crank. Sure an 03 cobra had a hell of an engine, but it didn't have a kb supercharger.

[tobroke2007]

nice real nice are you running this on stock bottom end? and could you hint on how much the KB cost you with install?

[The808monsta]

very nice! i got a couple vids of my old gt before my wreck and i had a vortech up front. only vid where i got it though and thats in front of mcdonalds. other mods were 4:10 gears, borla s-type catbacks, mac o/r prochamber, headers, lowered with some h&r supersports and bilstein adjustables, and of course basic bolt ons as well. and a tune. i dont have vids of the 4.10 gearing or the full exhaust set-up. just borla's /:

check my channel!

[MrToyo96]

Anyone selling a supercharger for a 01 gt

[RyanMizzell]

As soon as you pop the hood you can hear the blower setup whistling its super clean gotta love kenne bell blowers!

[camelsamul]

wanna trade?

[rgv2006tx]

is that a homemade air filter cover??

[mattmonster93]

So..ummm....when you giving this to me? lol

[04kbgt]

@000JERRY0000 You change the pulley to change the boost. Id recommend having a shop do it,

[disneyprofessional]

nice car man, I've got a 02 gt myself, having the 2.1 kb installed @10psi. It's cammed and I'm throwing on a Dragon Performance throttle body and plenum along with an 85mm MAF, upgrading the fuel pump and filter, installing a new clutch and going with an aluminum driveshaft. I'll post a video when the work is finished.