daytona knocking
Loading...
Loading...
213
views
Loading...
Uploader Comments (supermoonbeam)
see all
All Comments (8)
-
dude the bad thing about 2.2 liters is once the bottom end goes you got to rebuild although they will continue to run, they're kinda like a 225 slant six they go forever whether taken care of or not
-
@supermoonbeam sweeet good job man
-
Nice car though!
-
Ow, sounds painful. Rod bearings probably
Loading...
2:25
tossed a diff pin in a 543by supermoonbeam92 views- 0:52
Me at workby supermoonbeam113 views
- 2:53
My 1966 Plymouth fury with 440 and dual quads & Aluminum headsby slowmotion4x44,107 views
- 0:33
1990 dodge daytona commercialby reich967488 views
- 3:52
Starting the loud 3.0 daytona.by tona6g72550 views
- 0:35
1993 Plymouth Duster 3.0 litre revs at 150 rpm !by djackson9504789 views
- 0:23
dodge spirit 3.0 5 speed accelerationby supermoonbeam743 views
- 0:45
The Real Blue 71 Rev's its Motor! (HD)by Gtczy666Challenger1,244 views
- 0:19
1990 dodge daytona commercialby reich9674,474 views
- 9:02
Mike Skeen: 2010 GRM UTCC Dodge Challenger cockpit viewby michaelskeen7,629 views
- 0:21
Lifter Noiseby cgbaseball2393,106 views
- 1:42
1971 plymouth duster small block 4-speedby mcnett45614,408 views
- 3:45
Dodge Spirit 5 speed swapby supermoonbeam1,100 views
- 0:27
93 dodge spirit 5 speed swapby joemadoo110 views
- 3:56
Nitrous Install on a 95 Dodge Spirit 3.0by supermoonbeam6,289 views
- 2:46
1998 Toyota Camry LE Bad Piston Bearings/Rod Knock And Lucas Oil Additiveby iceplusplus18,766 views
- 15:57
Bob O'Neill on do-it-yourself bodywork and car paintingby allparcom904 views
- 2:43
1994 Dodge Spirit V6 3.0Lby parentsimard6,759 views
- 0:12
95 dodge spirit 3.0 with a 35 shotby supermoonbeam4,290 views
- 3:25
My Indy Red 1991 Dodge Spirit R/T (1 of 774) / Exteriorby DaPepster15,391 views
either rod bearings or a bent valve or the hammer is getting a flat spot
nikorussion16 1 year ago
@nikorussion16 spun bearing. I replaced it and it runs lol. Same crank and rod, only did a bit of sanding with 600 grit paper to make sure it was smooth.
supermoonbeam 1 year ago
I need to put up a new video, but I pulled it apart adn I had a spun bearing. I put a new one it and it runs. Bit of piston slap, but it runs.
supermoonbeam 1 year ago
I'm gonna change out the rod bearings and the mains I can change out without pulling the trans or crank pulley
supermoonbeam 1 year ago