Blaster cylinder porting Exhaust, part 2.wmv
Loading...
Loading...
6:28
Blaster porting part 3.wmvby koconnor0718,368 views- 9:06
Blaster cylinder porting Exhaust part 1.wmvby koconnor0719,087 views
- 2:10
Porting tool right angle for 2 stroke transfers182.MOVby TJHAGAN36,438 views
- 3:25
Arlan Lehman Talks About 350 Power Valve Cylinder Portingby LEDPerformance7,848 views
- 1:47
How To Skim A 2 Stroke Cylinder Head Using Household Toolsby denzlepob25,061 views
- 1:35
THROTTLE BODY PORTING WITH HOME MADE CNCby matthieu1498,133 views
- 8:59
240 tear down .wmvby koconnor077,000 views
- 14:06
Blaster Engine Assembly part 4 0001by koconnor072,306 views
- 12:03
Blaster Engine Assembly Part 5by koconnor074,830 views
- 9:04
Ironhead Intake Port, Polished vs. Scuffedby oldkarkid4,072 views
- 0:38
Exhaust port 088 halfby mweba11,351 views
- 9:21
Bottom end assembly 1by koconnor072,466 views
- 9:33
How to measure a cylinder.wmvby koconnor076,027 views
- 2:54
Two stroke engineby masterconcept253,550 views
- 7:26
Engine build part 4by shinyredped3,979 views
- 4:25
Annealed Head Gasket.wmvby koconnor071,698 views
- 3:03
CR500-AF PROJECT PART 11...ITS DONEby groutaone137,852 views
- 9:45
sportport part 1.wmvby kenoconnorracing1,408 views
- 1:16
How to Install 2 Stroke Piston Ringsby slaverace115,997 views
I hate new sand paper rolls I usually hit something with it first to round off the tip. Also there is a company that makes a wax block that you hit with the sander and it lubricates the sand paper and leaves a very nice finish. Nice work....
bligrigs 2 weeks ago
apik tenean
anayatriono 5 months ago in playlist Video Favorit anayatriono
You must use oil! in contact with the cutter, a much better job!
greetings from Polish:)
Berciuu 8 months ago
Thanks for uploading these video's Koconnor07! Keep this good stuff up!
Urtaget 11 months ago
@Tyler1Blaster A Junk cylinder is nice to practice on, but if you dont run it, you wont see if you made more power or not :)
RubberSalt 1 year ago
these are good vids ken. i need to find a junk cylinder to try this on.
Tyler1Blaster 1 year ago