How to Rebuild a Turbo - Part 1 of 2

Rebuilding a td05h 16g turbo. This process can be applied to many journal bearing turbochargers. :) It definitely come in handy to know how to do this when you are in this type of hobby.

keywords: turbocharger dsm eclipse talon awd gsx tsi fwd gst mitsubishi evo evolution lancer 14b 20g td06 td06h td05 install installation upgrade race vs boost supra wrx sti toyota subaru dyno laser rs rst 13g hx35 hx40 holset 18g 25g sbr t25 stock replace rebuilding big large nissan 240sx t28

Category:

Autos & Vehicles

Tags:

• turbocharger
• dsm
• eclipse
• talon
• awd
• gsx
• tsi
• fwd
• gst
• mitsubishi
• evo
• evolution
• lancer
• 14b
• 20g
• td06
• td06h
• td05
• install
• installation
• upgrade
• race
• vs
• boost
• supra
• wrx
• sti
• toyota
• subaru
• dyno
• laser
• rs
• rst
• 13g
• hx35
• hx40
• holset
• 18g
• 25g
• sbr
• t25
• stock
• replace
• rebuilding
• big
• large
• nissan
• 240sx
• t28

[areyouyo]

make sure your engine oil is good because he most likely put to much and yeah u should know the rest.

[jjrock5]

@areyouyo You mean oil pressure?

[MrDroid1985]

Were did you get the 20g kit.

[jjrock5]

@MrDroid1985 eBay

[luvnish]

"Wipe your shaft... heh heh heh" HAHAHAAHAHAHAHAAHAHA

[8meanmachine8]

Dude there is a Spider on your Desk @ 5:55 lol

[CLIFFOWNS]

spider at 6:06 lol

[mike3247m]

Did anyone else notice the spider at 6:00 lol

[jacobdezitbetter]

stupid harbor freight snap ring pliers FUCK YOU!!!

[zonetraveller]

Hey man thanks for this video. Funny enough i dont have turbo issues and don't even have a car with turbo. But watched video anyway cos it was real educating and well fimed. Thanks again

[MIKECORTI]

the wipe your shaft definitely got me lol

[Mistostretto]

An open exhaust can cause the turbo to leak oil on the turbine side too, because the turbo needs back pressure from the exhaust. Otherwise the pressure balance between the different houses is out of balance wich will result in an oil leaking through the exhaust.

[Hondas337]

you should invest in a set of picks :) screw drivers are for screwing, but overall great video!!! plan on rebuilding a td04, any suggestions on a place to get a quality cheap kit? bearings and seals

[Hondas337]

@8meanmachine8 rofl so sketchy



[touyang55]

so is this for every turbo that u can rebuild or is it just for only this turbo that uses this steps

plz question back

[Jayeeyee]

If you're swapping in a G20 wheel/turbine.. doesn't that mean you'll need to have the shaft/blade re-balanced? This is a very important step since turbos spin at like 10k rpm and u want everything mechanically sound and balanced.