redneck gas can modification fastest gas in the south

just a video of a sorta redneck gas can mod ,who likes the new non vent gas cans ....nobody so here is how to add a vent to get the gas out of the can so you can use whatever you are gasing up before you get gray hair !! 2 bucks and half beer job lol

Category:

Howto & Style

Tags:

• gas
• can
• redneck
• fuel
• modification
• beer
• ford
• chevy
• chevrolet
• pabst
• blue
• ribbon
• white
• socks
• bullshit
• everything
• else
• and
• partridge
• in
• pear
• tree
• thomas
• engine
• start
• yellow

[dwasifar]

I hope his fuel filter catches the plastic shavings he just poured into his tank.

[towrecker]

@dwasifar @dwasifar spout of the can has a fine mesh filter , also there was not one shaving in the can anyways ,as a plastic drills into long curly shavings , and the twist of the but pulls them out , think about it ....

[dwasifar]

@towrecker Yeah, I posted before I watched to the end and saw that you had a screen in there. I thought sure you'd wind up with some shavings from reaming the hole with the bit going in and out, but the screen makes all the difference. Sorry about that. I did post a "never mind" followup but I guess you didn't see it.

[towrecker]

@dwasifar well I have seen it now , I hadn't then though lol

[stevenabb]

New gas cans are a TOTAL NIGHTMARE!!! They don't have a vent port so they guzzle and spill all over the place. I have a car that I can not fill with gasoline because, it has a safety device in the gas tube ( on the vehicle ) and the small spouts will not reach it to push it open. Try using this NIGHTMARE gas can with one hand while fidling with the safety spout with the other. Sorry, but 5 gallons of gas going out at 1 gallon per minute gets pretty heavy. HORRIBLE!!! Destroy the safety feature!

[towrecker]

@stevenabb you should see what I did to one of the new cans , I made a lock for the valve , and added a vent !!! it works even better than the old ones now ...don't tell al gore lmao !!

[ebtrr]

@stevenabb They sell long narrow funnels at the auto parts stores. You stick one of those in the fill hole and it holds the safety door open. You can then pour into the funnel from your can - after adding a vent hole. (all hypothetical, of course!)

[hunter548]

@towrecker - Good video. I did a similar mod a while ago. Drilled a 1/2 inch hole in the gas can in the same area and used a coat hanger to pull one of those rubber wheel valves through the hole in the can from the inside and ditched the schrader valve. Same principle. I think your way was a little easier. Screw Al Gore.

[dwasifar]

@dwasifar - never mind, he has a screen, should have watched to the end before I said anything.

[towrecker]

@NURSECHANEY well there is a cheap fix lol , and it works great !