Bagged Truck - Parallel 4 link

Parallel 4 link kit. This video shows how to weld a parallel 4 link kit and panhard bar.

Category:

Autos & Vehicles

Tags:

• Air bags
• Air suspension
• Step notch. lowrider

[prizonlizzard]

so did you have to raise your bed floor or notch that out to? i want to do the same setup on a 96 sierra reg can short wheelbase. what mods did you have to do to make the bed fit and can i make this work without body dropping

[josegasca]

@prizonlizzard, I decided to notch it out. It was more convenient for me since it requires less fab. That's pretty much everything I had to do to make the bed fit, well almost everything, I also had to remove the front bed supports, the ones closed to the cab, they were on my way.

[fastjoon92]

Hi..just like to say I've watched your video many times and can't wait to work on my on street scraper. I have a couple of questions. First being when you welded on the 4 link, how did you make sure both sides were equally spaced? In other words one side of the axle points inwards than the other. Also I am looking at a weld on 4 link from avs and theres is circular rather than a straight piece to weld to, is that were I weld? Forgive me if my questions seem rather less than intelligent lol

[josegasca]

@fastjoon92 , Before u start tearing ur truck apart u have to take a lot of measurements. For instance, measure from the center of your axle(passenger & driver side) to a fixed point (of the frame) close to the cab, when u install your 4link, these measurements have to remain the same, that's how u know they are equally spaced. Send me the link which shows this 4link u want to purchase and we'll take a look at it. And remember: "The only stupid question is the one you don't ask".

[SSFTC]

nice craftsmanship, your obviously skilled in your trade!

[josegasca]

@SSFTC, thank you ssftc. I am glad people like it and I hope it helps them in their own projects.

[fastrider656]

they put this in a bag!?!?!?

[kustomkenny]

u should make your own custom frame

[josegasca]

@4kaitlynmd, I bought all my stuff online. Go to suicide doors dot com they have everything u will need. I think I paid around $1000.00 for my kit. Those look awesome man, be sure to make and upload a vid for the entire community to see.

[4kaitlynmd]

@josegasca Where did you get your kit at and how much did it run you? Im really considering it but i want it to do away with leafs. I hate them. Im going to do a parallel with the pan hard, but use air shocks to level out the five inch drop up front. Im a fan of bagged trucks, but right now ive got a 94 ford and i think it looks better with 15x10s and 295/50s