Smack Install part 2!!!
Loading...
Loading...
30,661
Loading...
Uploader Comments (EletrikRide)
see all
All Comments (10)
-
I can't wait to start working on the basics this winter. Great vids with good comments, keep going... Montreal here : )
-
hey smack. How would you set this up if running boost?
-
Hey Smack you know your shit about engines. I have a few ideas floating around my head that I want to try out. I think if you feed the Smack unit into a turbo intercooler along with a fine water mist it will give more mpg and give a cooler runing engine. I have seen turbo cars runing bigger bhp with an IC water spray system. I am also going to try to run an enigne on hydrogen and pure water mist sprayed into the cylinder like an old steam engine I know this will work
-
Nice work and attention to detail :D Engine looks wicked.
Loading...
8:25
HHO VMU Vehicle Management Unit x (Alexis) Hydroxy Boostersby hhoforeverdotcom34,278 views- 4:37
Smack Install Part 3by EletrikRide9,340 views
- 1:02
hydrogen fuel cell HHOby jaded10218,394 views
- 7:22
TJ cell installed and test run part 1by HHOhotrod6,535 views
- 3:52
Battery relocation Smack installby EletrikRide6,463 views
- 6:41
TURBINE Alcohol Pepsi Can Jet Engine Stove DESIGN #3by twoliterpepsi451,362 views
- 2:20
Booster Rally part 1by EletrikRide31,740 views
- 7:00
#81 - VSPB cell chamber construction part 4by ZeroFossilFuel27,570 views
- 2:21
Oxygen Sensor Voltage Boostby sm0ky4064,991 views
- 8:52
GenIII story part 1.by EletrikRide11,377 views
- 1:52
Hydrogen boost running car on hydrogen, Improved ignition & running.by ChrisPCrunchy1,939 views
- 6:53
Mods to the Smack part 2by EletrikRide10,593 views
- 6:14
On Demand HUGE Hydrogen Production, How to Make Hydrogenby knowpub687,632 views
- 1:10
Drop that Ride!by EletrikRide4,674 views
- 1:24
Simple PWM Smacks Booster LPM flow WOWby wwwtacnalcom12,060 views
- 1:20
Hydrogen Fuel Cell with 5 plates. Completed Unit! mixcatcom HHOby mixcatcom661,475 views
- 0:43
Hydrogen Generator Saves 20% - 90% Fuel and Increases Powerby hydrojuice341,642,007 views
- 7:09
Intro to HHO 4of4by webovisionca5,231 views
- 9:37
HOH Cells - Mileage increased by over 50%by hohcells25,041 views
- 8:25
Analyzing The GenIIby EletrikRide12,245 views
What amount of EGT temps do you see on the bike, with and without the booster?
Ulai777 3 years ago
Depends on how I'm riding. EGT's go all over the place depending on engine load.
EletrikRide 3 years ago
If I wanted to inject it also through a vaccum line with an additional bubbler, would that be advisable??
tolipapa1 3 years ago
No, bad idea.
EletrikRide 3 years ago
Where do you think is best location to inject the gas, before the MAF sensor or after?
tolipapa1 3 years ago
Before would be best
EletrikRide 3 years ago