Uploader Comments (3DGAMEMAN)
All Comments (17)
-
A few mods
1. Route tubes in case to pass over intake air
2. Put tubing inside the reserator on nipple that dumps the hot water in. This is near inlet nipple. Make the tube reach the top of the reserator to dump the hot water on top, letting it cool before going back into the system
3. Put a circular fan under the reserator so the fan air goes over the fins
4. . Put something around the reserator to enclose/channel the fan air
Doing these will lower your temps about 20 degree F
-
Hello Can you please TELL me can this awesome cooling sistem GPU water block fit my ATI Radeon 3850 AGP graphic card? Thank You for the infofrmation. ( Sorry for my speling mistakes )
-
One question. CAN THIS WATER COOLING fit my ATI 3850 , cuz i have this water cooler , i only use it to cool my CPU ...
-
if u want ur cpu to be at BITCHFUCKED temperature ... dont buy this . my CPU temp with FAN is 60 Degreese , With RESRATOR 1 40 Degrese
-
Looks so tall and long lol.
-
Hahahaha, you can buy V2 tubes (almost cost 0), or go to a random utility shop and get any tubes for V1 you like.
-
Buy the V2, looks better with see thru tubes.
Good design concept but comes short in alot of places, such as weak waterpump, cheap waterblock, and bad performance all around, 41c idel /60c load? and cost an arm and a leg $230 and compare to my Evercool 201 which has an 38c idel 42c load this is bad. the only good thing I like about this package is the tower reservoir.
gnuelk 5 years ago
FYI: I will be video reviewing the version 2 soon.
3DGAMEMAN 5 years ago