LIYU SC631 & SignCut Pro - Open, Settings, Cut and Cutting

This is my LIYU SC-631 that I bought from ukcutter.co.uk (from eBay). A little video of how I cut vinyl using the SignCut software that is a £12 optional extra from their eBay listings. Using KPMF vinyl from MDP Supplies. The vinyl was a little dirty but will be cleaned before weeding and the application tape is applied.

After I made the video I adjusted the blade to just over 0.5mm with '25g' of pressure from the cutter itself. Great cuts and made for effortless weeding. The cutter can go up to 800mm/sec if needed.

Any comments or questions, please post below :-)

Shot on my little JVC Picsio (GC-FM1) in 1080p. Edited in Final Cut Pro (quickly).

Category:

Science & Technology

Tags:

• LIYU SC631
• SignCut
• Pro
• Open
• Settings
• Cut
• Cutting
• KPMF
• Vinyl
• JVC
• Picsio
• Final Cut Pro
• Process

[MrJonnyJones]

@CAPOTHUGRIDERS You can increase the cutting speed (mm/sec) on the cutter. In the video the cutter was set at 300mm/sec. But since I made this I've started cutting at 200mm/sec as this gives you nicer cuts. Turn the cutter on and use the left/right buttons to increase or decrease the cutting speed :-)

[CAPOTHUGRIDERS]

great video. im using the same software but its cutting very slow, your video is cutting very fast. any suggestions? thanks