Bmw E-36 Turbo 500hp

The last pull gave 501hk and 632nm @ 1,8bar...
going to make a homepage when i have time and nothing else to do :)

Category:

Autos & Vehicles

Tags:

• BMW
• dyno
• TURBO
• finland
• M50
• 500hp
• penkki
• suomi

[SkywalkerTibor]

turbo lag is fuckin huge

[Fiido85]

@SkywalkerTibor

not good for the turbo when i hadn´t a blow off valve but mounted it after the dyno...going to make a new dyno video when i have upgraded the machine (but need some money for that before i can do it)

[e34tote]

is thath with m50 engine?

[Fiido85]

@e34tote

Yesbox...m50b25...made a bad mistake when i builded the machine when i didn´t took the crankshaft from a b28 before that crank is forged and i would have 2,8l and not 2,5...

[Ellersgaardrazz]

R*E*S*P*E*C*T*!

That is how you tune a car. Wish it was mine ;-)

[Pixieczek23]

och ...Turbo have nice sound.... sweet car ...

[doldei]

@Fiido85 You car must be something , I'm now taking Automotive Engineering Degree back here in Portugal , it will take some years till I get myself a paycheck to pay for all the major stuff ! For now it's only direct KN air intake and small bits like that ! L6 is one and a half times more pricy to tune , instead of 16 we have 24 , kind of sucks ... but then you ear it roar and it all goes away ! Alchool ( and water ) or the CO2 shots on the intercooler are not that expensive and doable at home !

[Fiido85]

@doldei

Yes i have ~8,5:1 compression now...and yes i have polished whole inlet,runners,ic pipes, compressor side on turbo and much more stuffs...yes money is always a problem :/

[doldei]

@Fiido85 You had to lower the compression rate a bit, right ? Go stainless headers, and polished air inlets ! Not that expensive and with some work it could be done at home ! The intercooler could be sprayed too , with alchool , co2 or no2 dry shots ! Ahhh, the time and money ... my problem exactly !

[Fiido85]

@doldei

Thanks!

i doesn´t remember 100% if it cuts at 7000rpm...need some more money now so i can build everything i want....change cams,fuelpump and lot more..so we shall see if it´s ready for the road to next summer...depends on moneys and space to be in and build :)

[Fiido85]

@e34tote

Yes! M50B25

[doldei]

@Fiido85 1,6 will be my limit one day ... when I get my hands on some garret ! I gess 1,8 for an engine with some parts , coolers, hoses and stuff ! But I gess you had some internal work too ... nice valve sound ! It cuts around 7000? 7500 ?

[Fiido85]

@doldei

not if it only is 500hp/632 torque...it´s not more because it´s original cams