1UZ Adapter Water Cutting

This is simply a waterjet machine cutting out the adapter plate for me out of a 1/2" piece of plate steel. The whole process took 25 minutes. The holes were cut but will need to be ran through with a mill just to ensure they are perfectly straight. Then some of the holes will be counter-bored and tapped.

Category:

Autos & Vehicles

Tags:

• 1UZ
• adapter
• plate
• lexus
• engine
• w59
• transmission
• waterjet
• water
• cutting
• machine

[Jay351]

Awesome!

I want to do the same swap into my 91 pickup, too bad the r150f bellhousing adapters are so much!!

get more videos up man!!

[casmitherz]

@Jay351 I'm working on it as fast as I can. The ECU is not accepting the signal from the LC-1 wideband and it should be an easy hookup. Dumb thing! I'm waiting on a response from the tech guys cause this shiz shouldn't be an issue.

[Jay351]

What trans?

[casmitherz]

@Jay351 The ol' Tacoma W59 5spd. The truck is 4wd and almost done if you want to check it out trying to start in my other videos. Programming the standalone ECU is a PITA!

[Jay351]

Good luck mang. heres hoping its an easy fix. That thing has been in the works for too long :) Its time to enjoy it hehe