Washer Repair DIY

http://www.ApplianceRepairLesson.com

This video explains how to remove a front load door gasket to replace it. You may also need to remove the door gasket to access the door latch assembly behind the front panel.

Category:

Howto & Style

Tags:

• Kitchen
• Aid
• Kenmore
• Whilrpool
• front
• load
• Bosch
• Help
• Repair
• Remove
• DIY
• latch

[ApplianceAdvice]

On this particular machine the rubber boot fits over the metal rim. There should be a notch in the boot to fit over and under the rim if that makes sense. I usually apply a small amount or liquid soap in the notch to help it slide into position better. This job can be a real pain, stay with it friend you'll get it.

[ajsplus10]

Thank you! Third video I've watched and yours is the first to actually SHOW me how the gasket attaches.

[fish113d]

Personally, I just tried getting the spring rign around the back of the gasket, and even with liquid soap, I cannot for the life of me get it to NOT pull out on the opposite side when I get it 2/3 of the way on...help?

[bhamlad678]

THE PERSON WAS GOOD FOR DOING THAT JOB IT MUST BE A FEMAEL OR MALE DOING THAT JOB 

[63801170]

On the rear fitting can you explain if the rubber usually fits over the metal rim or under (inside) the rim. I trying to refit a new Simpson 45S710E gasket (boot) and I can' find any service manuals to say how it should sit on the rear rim? I think it should sit over it, but it doesn't seem to sit very nicely?