SSG Fan - Watching Batteries Discharge and Charge

12/12/11

Just a video showing the performance of the SSG brushless fan conversion.
As you can see in this video, each time I swap batteries, it takes LONGER to charge the previous battery.

This typically ends with both batteries needing a conventional charge from the bench-top charger.

I have never seen any of these radiant energy mechanical oscillators actually maintain the batteries; let alone provide any useful energy out. No matter how well I build the device to incorporate the best bearings, most aerodynamic, best tuned, most coils, Litz wire, etc.

After experimenting with many different configurations including Rick Friedrich's three coil kit with pulsing capacitor option, as well as this fan conversion, and many others I have built, the end result is always the same; two or more dead batteries.

And an interesting conversation piece that has taught me a few things about pulsed DC systems.

Yes, a lot more efficient, but no, nothing over 100%.
Not as they are. If this particular technology is ever to achieve anything higher than 100% efficiency; it will be with the help of something else such as Tesla battery switching and/or a coggless alternator.

Of course, if I am going to build a coggless motor-generator, it will be more along the lines of a Muller/Williams dynamo and not an SSG.

Better yet; would like to learn more about vortex energy possibilities and how to build some type of toroid coil that actually allows the wires to resonate.

That IS the secret to a self sustaining system of this type.

The windings need to be wound in Rodin coil fashion but in some type of SUSPENSION such as foam rubber. This way a RESONANCE may be accomplished in tune with the Schumann resonance. Then the energy can be amplified.

I do believe this is the secret of Toroid Power Unit (TPU).
A coil, suspended in rubber, that is allowed to actually vibrate (resonate) at a specific harmonic of the Schumann resonance. Then other coils in the CENTER of the vortex that ties everything together in a functioning system.

Wish me luck on trying to figure that one out. . .

Scorch.

Category:

Science & Technology

Tags:

• Radiant
• Energy
• Power
• Bedini
• Friedrich
• Tesla
• Battery
• Oscillator
• Power (physics)
• Toroid
• TPU

[MrArrow1961]

Dear Scroch you said - "The windings need to be wound in Rodin coil fashion but in some type of SUSPENSION such as foam rubber. This way a RESONANCE may be accomplished in tune with the Schumann resonance. Then the energy can be amplified."

I want to know the efficiency of last part that is called energy amplifier. Do you think that there are such amplifiers that has 100% efficiency? I am not sure on this on 99,5%...guess we are looking at wrong side to find phenomena of >100% efficiency.

Rob

[ScorchGD]

@MrArrow1961 Please forgive me, I used that term in a general sense. I am thinking in terms of some kind of step up transformer, or other system, that may accept a low frequency, long wave, resonance generated by a harmonic (near the Schumann resonance), and convert it to something more useful with a higher frequency. Could be just another toroid coil, or two, that operate at a higher harmonic. I am just guessing. And the original TPU videos are very intriguing.

[MrArrow1961]

Hi dear Scorch,

Bedini him self refused that batts can be changed by their place. If we will change batts he said to Russia correspondent, then both batts will be discharged. Sorry, I did not found this video below in English. Actually you prove by your experiment his words.Only what is positive can I see here – in such setup B batt will be out of sulfatation , and will go up by its normal written capacity. That is true because there are high impulse voltage at B batt side.

Truly,

Rob

[ScorchGD]

@MrArrow1961 It is my belief that Bedini's systems CAN work. Just not sure if its very practical if they require a pair of huge battery banks for a home power system. See: "Practical Guide to Free Energy" wwwDOTrodscontractsDOTws/docs/­Practical_Guide_to_Free_Energy­_Devices.pdf

[min2oly]

your SCR cap dump does not seem to be working. Have you scoped it?

[ScorchGD]

@min2oly I did when I originally built it. It is switching, but at a pretty high rate, so not really visible on the DC meter.

[ScorchGD]

@min2oly Yes. See: wwwDOTrodscontractsDOTws/image­s/projects/PulsedMotor/fan/fan­2/

[overunitydotcom]

As the motor uses up the power mechanically you will

have a longer running time with the Bedini back and forth switching,

than run the fan on each battery alone and add these 2 running times

up.

[overunitydotcom]

If you would use a lower drag motor you could probably increase the charge on bother batteries,

if you have the right pulse waveform to charge up your batteries.

Just show us a few scopeshots, so we can see the waveform on a shunt rsistor, so that we can see the current waveform you use to charge up the battery with. Many thanks.

Regards, Stefan.

[GuardianZeus21]

@ScorchGD So even after creating an either battery you were still unable to get a COP grater then 1? My Understanding is that a self running fan for instance requires a multistage circuit that shuffles the different energies around and keeps them separated. Kind of like what Tesla used to do with his multi coil setups. Simple circuits are almost impossible as the components were not designed for that type of energy. All good work tho and thank you for your posts.

[MrArrow1961]

@ScorchGD you know ,Schumann resonance is OK, but all these are very complicated to pass relevant simple tests in the way. We need instruments with memory etc...to log all results for further research deep analysis. Probably some one will accomplish this task , by this guys will be from very reach research laboratories, not us, sorry. Actually buy this information in the internet we are pumping up jobs and money not for us, not fro general people to copy and save their families.