Cable Organizer Kit with Power 50-3323-WH-KIT,Wall Mount TV, HDTV Installation, Home Theater

Click the following link for a list of retailers: http://www.datacommcableorganizer.com. Use DataComm Electronics' easy-to-install Flat Panel TV Cable Organizer Kit with Power to install power and hide unwanted audio/video (hdmi, component video, etc) cables in the wall behind your wall mount tv, lcd, hdtv, or plasma flat panel TV. This kit brings a clean, professional image to your at-home lcd, hdtv, or plasma flat panel tv installation.

Since this kit does not connect to your homes existing wiring, there is no contact with live electrical circuits. To install, connect the two Recessed Cable Plates using electrical wire. Plug the female end of the extension cord into the Recessed Cable Plate with Straight Blade Inlet and the male end into a surge protector or power outlet. This connection will bring power to your hdtv, lcd, or plasma TV or A/V equipment. The Flat Panel TV Cable Organizer Kit with Power comes with simple instructions for a quick and easy flat panel, lcd, hdtv, home theater or plasma tv installation.

Category:

Howto & Style

Tags:

• cable organizer
• home theater install
• diy
• d-i-y
• flat panel installation
• flat panel install
• plasma tv
• wall mount
• lcd
• hdtv
• plasma
• av cable
• av
• wiring cable
• cable
• hdmi cable
• home theater cable
• hdtv accessories
• hdtv cable
• hdmi
• av wall plate
• wall plate
• in wall cable
• recessed plate
• pass thru plate
• bulk cable
• home theater
• home theater in a box
• datacomm
• datacomm electronics
• data comm
• data comm electronics

[amylchapman]

Pardon my ignorance, but if you have to have a wire running from your existing outlet to the other one you installed then what's the point? Aren't there products that hide the wires ENTIRELY?

[DataCommElectronics]

@amylchapman Thanks for your comments Amy. The kit enables you to have power behind your TV hanging on the wall using one plate, phish the wires behind the wall to the second recessed plate. Codes do not allow phishing the power cord from the TV behind the wall, and this kit allows you to plug in your TV to the recessed plate with power behind the TV. Using the supplied extension cord, you connect the bottom recessed plate to a surge protector or power source.

[DataCommElectronics]

This product is not made for the European market at this time, but thank you for your interest.

[7bigseon7]

I bought this kit. The video was very helpful. When I was tightening up the screws on the right side of the cover plate I had to use all my strength to get the screw to through the plastic holder tab. I am an electrician and used to using a screwdriver. When the gal in the video screwed the screws she just help the screwdriver with a couple of fingers ....no way...It was extremely hard. She also forgot the 2 screws on the left side of the cover plate

[DataCommElectronics]

@7bigseon7 Thank you for your feedback. We are sorry to hear that the screws were a bit tight on the kit that you received. That should not be the case as they are designed so they can be screwed in using a manual screwdriver. We have made note of your issue and will make sure that product development is aware of it.

[ranthewireman]

I enjoyed the video. Nice job and nice information however that could be a code violation! check your wire gage!

if 20 amp breaker kills outlet you must use 12/2 wg(YELLOW WIRE), 14/2 WG is WHITE and will work fine if a 15 amp breaker kills outlet!

improperly sized wire violates National Electrical Code!

whose intention is FIRE PREVENTION!

[DataCommElectronics]

@ranthewireman

Please note that the product is design for residential use only so there is not a code issue. The 50-3323-WH-KIT comes with a U.L. approved 15 amp receptacle and 14/2 with ground building wire. The product is designed for use with 15 amp circuit breakers only.

[AMOVIEROOM]

DId U see that? @ 3:55 somebody passed her the cable behind the wall!!!! But it's a great Vid non the less I know u did it for time sake :)

[LapseOfLuxury]

@itsmegino It's code in CA to have fireblocks between studs at about 4' high.

[Bretzelbueb]

Wow, american walls are so thin! I would be scared if the TV holds on that wall.

[GrampaDenny74]

@DataCommElectronics I just recived my kit and have the same exact problem with the screws not tightening, complete junk, other than that the kit wasn't too bad.

[TeamZulu1]

is there anything like this in the UK???

[newyorkerinla]

Thank you so much! I did it, after watching another video on mounting my TV, finding studs and all that jazz. Thanks again, this completed my set up in my new loft. You rock!

[loladogg22]

Just ordered the kit should get it by end if the week. Will come back and review installation process.

[raztastic007]

very nice video, very helpful thank you.