FAB 3000: Rout PCB with tabs in a panel
Loading...
Loading...
148
views
Loading...
Uploader Comments (NumericalInnovations)
see all
All Comments (2)
-
Is there now was to add tabs to the panel between each job automatically? I would like something to automatically do the tabs without much input on my part
Loading...
2:30
Construct an NC Rout Path from a PCB Border using FAB 3000by NumericalInnovations130 views- 1:48
Generate PDF Checkplots from Gerber/Drill using FAB 3000by NumericalInnovations193 views
- 1:29
Merge 2 Gerber jobs to one panel using FAB 3000by NumericalInnovations127 views
- 1:14
FAB 3000: Import DXF, use join and export to gerberby NumericalInnovations116 views
- 3:32
Generate X/Y Centroid file from Gerber, using FAB 3000by NumericalInnovations1,488 views
- 1:21
Extract Netlist from Gerbers and View Nets using FAB 3000by NumericalInnovations245 views
- 1:03
Using FAB 3000 to add copper with clearancesby NumericalInnovations123 views
- 2:44
Sort Layers and then assign Blind/Buried Vias using FAB 3000by NumericalInnovations80 views
- 0:36
Generate Paste Layer from existing soldermask layer using FAB 3000by NumericalInnovations87 views
- 2:35
Create a Fab Drawing from Gerbers and Drill layer using FAB 3000by NumericalInnovations97 views
- 0:41
FAB 3000: Import Image file and export Gerberby NumericalInnovations46 views
- 0:06
PCB V-cut scoring machineby IsWorkingMan839 views
- 7:50
Routing a PCB with EAGLEby adafruit24,874 views
- 1:56
FAB 3000: Import Logo Image and merge with PCBby NumericalInnovations55 views
- 1:46
Using Convert to Custom Aperture with FAB 3000by NumericalInnovations60 views
- 3:42
Online Gerber Viewerby icetheripper506 views
- 1:10
Stretchable PCBby ExpressCircuits1,317 views
- 3:03
OrCAD PCB Editor - Multi-route & Arc Controlby TeamOrCAD2,848 views
- 1:13
circuit board diode routing number panel one - zero past nineby deretraum275 views
- 14:37
PCB Copper Panel Plating Through-Hole / Via Tutorialby PatheticComputing19,437 views
* You will need to repeat these steps for the other jobs. Notice how when you add the routs to the job, they automatically show up in the panel
* The direction of outer routs should be CCW, and inner routs CW. However you should contact your PCB vendor to confirm their preferred direction of routs.
* You can take the extra step of adding cutter compensation which I did in this example.
* Some PCB vendors prefer to have plunge/retract points off the board.
NumericalInnovations 2 years ago