Building homemade snowboard box

To make you will need 3-2x4's,,1-2x6,, Plexiglass,, Box of screws (I got 2-1/2 inch),, Screwdriver,, Tape measure,, DRILL BIT ( If u don't pre-drill then you will crack plexiglass),, paint if you want to paint stuff on it...Now first step is to get all supplies and get wood cut (make sure wood holding 2x4s together (2x6) do not stick out side) and get plexiglass cut (plexiglass is easier to cut with table saw) you can make your legs(2x6) any size you want just make sure the sides that hold 2x4s together don't stick out side...Step 2 is to line the 2x4s up perfectly and place your 2x4 holders (2x6) on and pre-drill after that screw in all of the and make sure the 2x4s are held together tight... Step 3 is to get your legs on, so get your legs aligned,pre-drill, screw all legs in and stand it up.... Step 4 Make sure plexiglass is cut and does not stick off the box at all or the Plexiglass will crack and little pieces of plexi will fall off the box leaving a little gap,,, pre-drill the plexiglass and use a rounding bit or something that make a hole for the screw to go into the plexiglass but not all the way through and so that your board or skis wont hit the screw,, when all your plexiglass is on put and ur box is finished put some plywood pieces on the bottom of legs to keep stable. IF NEED HELP MESSAGE OR COMMENT. Thanks.

Category:

Sports

[littlepat21]

"dumberthanu54321" Ya it did work.

[dumberthanu54321]

did that work?