HHO Over Unity Protection

After 12 hours of testing no failures. If you want to build the posted circuit, I plead with you to include the protection modifacation.

Category:

Science & Technology

Tags:

• Meyer
• over
• unity
• hho
• bedini
• cell
• rodin
• coil
• lawton
• Protection

[Eddlipton]

Hi, l have built the lawton and RE-BUILT the lawton circuit . Over and over again,,Check my componet values ect. I really havent seen that much improvement in production over any of the other PWM I have built and put to test Including the LM324 units and mod's So if you can,,,, I would like to try your circuit but can't quite make it out on the screen/monitor. can you tell or send me via e-mail a schematic+componet list? I have built/wound the Rodin coil &Mods as well Thanks

[hhoforvolts]

@Eddlipton I don't know what happen to my posted circuit, it used to be HD.

E-mail me at rfmmars@cox.cox for the lastest.

Richard

[vid009]

when will you post the 800% circuit !

[hhoforvolts]

The link to the circuit use to be in the info box but is gone, and now I can't add it. I will send it to you by P.M. I have had as hi as 1700% with different setups.

[hgraphs]

iF you put a paper clip in a wall socket what have you learned ? Thank God for us whom survive curiosity and benefited.

[hhoforvolts]

Believe it or not as a small child, I put a paper clip into a light socket and I still have the scare on my right index finger............We learn by many failures

[ftlqed]

Or just put capacitors in series, that way you didn't shunt anything, and added tons of back pressures. Each capacitors constant slows the signal down until you get one deep cold cranking amperage. A car stereo just uses one, creating back pressure on the battery side, but the time constants of many slow the power back to the battery and heat up the overunity side.

[theoneagain]

8xA circuit is the way to go

[Eddlipton]

@hhoforvolts Hi Richard ! finally found a way to reach you!,,,tried thee e-mail address but dosent seem to go thru,, you can mail me at Edlipton88@yahoo.com and then I will "for security reason's" give you my ISP address,, had been having virus's hitting me and REALLY giving me a bad time here on this computor, down all wk end, Thanks Richard, Ed

[Eddlipton]

@hhoforvolts Hi Richard, I have been having "computor problems" AGAIN !!,

Have since tried to send you e-mail and it dosent go through, you can send me a e-mail at; edlipton88@yahoo.com and will go from there via "reply".

Thanks, Is this Thee "Ainsle circuit or a modified version?' Anxiously awaiting your response, Thank you in advance Ed

[Eddlipton]

@hhoforvolts would like to see some improvement in my effort too increase HHO production. Have tried many many PWM's and modifications but haven't been able to get past 30% improvemennt over orig MPG's. Lawton units ect. Haven't tried the Boyce yet and may well tackle that as well, could you please e-mail the schems& componet values to your circuit Please. Or tell me where too find it? It dosent show up well enough on the monitor to eliminate chance. Thanks Ed