dissassembly update on the yj axle

got her all tore down and ready to sandblast but a bit concerned about what to do about the inner seals..

Category:

Autos & Vehicles

Tags:

• leep
• yj
• dana
• 35
• rear
• axle
• tear
• down
• an
• re
• build
• gears
• sandblast
• jeep
• wrangler
• billstmaxx
• Jeep Wrangler
• County Down
• Down (band)
• 4x4
• Road
• Mud
• Offroad
• System

[KrzychOlsztyn]

Bill have You've got some more footage from Monster Jam ?

[billstmaxx]

@KrzychOlsztyn frigg ya racing and freestyle

[dluna1028]

have a pro set it up, unless u wanna take it back apart. Your gonna dicker. u better beg ur pard.

[billstmaxx]

@dluna1028 naw not gonna dicker were gonna weld it

[ChampTruex]

Bill what camera do you use ?

[billstmaxx]

@ChampTruex sony hard drive cam HD

[SrgScream]

@billstmaxx I heard you say that you when to primces auto and i was just wondering where in Canada do you live. :)

[travisjeanelle]

@Floridacracker1955 I agree its not for a novice doing the bearing and pinion. Got to be pressed just right then you need to put it together check back lash then put in shims or take out as needed.

[JOHNDEEBANK]

Hey Billie, Davisfarmlives just did a seal install on his backhoe. I know its not a jeep but he shows how to install bearings easier. U will get a lot out of it. JOHN.

[Floridacracker1955]

There are no inter seals.. That's a factory seal from the tube install into the housing. Make sure you load the bearings for the diff and the pinion before you reinstall it.. Truth is with your skills maybe you would want to have a mech s help for the rebuild.. Good luck!!

[steveandtot]

:kepp pushing :45

[zx8401ztv]

Smashing, looks like your having fun :-)

it will be much nicer to work on when youve sandblasted the hell out of it.

good vid bill:-)

[topfireman]

hey bill how much would a sticker the same size as the billstmaxx one run

[biggdaddy2001]

Boy bill you just created a cluster fuck for yourself by taking the diff out now u have to reset the backlash and a new crush sleeve for the pinion shaft good luck bill

[73pontiac]

Those o rings are correct for that. Also you don't needthe trackbar front or rear so cut them off.

[24carWon]

go to a junk yard and get a used axle