Blade mCPX mCP X - Setup and First Flight - Beginner's Guide Part 2
Uploader Comments (CrazyHeliDude)
All Comments (141)
-
I can fly 120 sr just fine, I decided to purchase the blade mcpx shown on your video. I can seem to get anywhere at all with it. I can hover it, but the smallest correction it goes wild. Most everyone on YouTube makes this look much more of a calmer helo
-
your battery isnt in all the way. Those tabs are supposed to go inside the tray and they hold the lipo in.
-
@christosioannides Idle up is when your rotor head speed is constant and the only thing that changes is your pitch as you move your throttle/pitch stick. You must use when doing anything upside down including flips.
-
Excellent tutorial
-
I have a question so i own the mcpx and when I took it out of the box and went to fly it I noticed when giving it throttle at a mid power lvling it is shakey also it seems the gear off the main roger blazed that goes to the motor seems to have quite a bit of play up and Dow and seems like it is barly on the pinypn gear how do i fix that?
-
page 5 in the manual says to charge your 200 mAh battery at 0.7 amps.
-
@Grrrrrene I would not jump from a cosxial heli to a cp heli it would buy a fix pitch single rotor heli such as the msrx or sr 120 but if u choose to buy this heli be careful inside you house because it is a hot rod. I fly mine outdoors or in large indoor areas. if u fly it is small areas it basicaly just hovering around ... wats the fun in that.
-
I have one of the 9958's it's also a very fun heli to fly. Beware, it's Fast. You can set it to low ratemby pressing themleftmstick down after you turn it on.
-
@Grrrrrene i would suggest u get the 9958 fix pitch. a lot cheaper than this.. it's a 4 channel...
call me dumb but after binding my dx6i with the mcp x"using the manual" it still wouldn't fly,then watching you say the throttle trim needs to be all the way down it now fly's.but squirrel y.could use advise on learning to control this heli.a video on dx6i settings would be great.and i been flying my msr,120sr for a while,just cp jitters
dosklown 2 months ago
@dosklown - Please see the comment I just responded to on my settings.
CrazyHeliDude 2 months ago
what seting do you have on your dx6i
ben2542 2 months ago
@ben2542 - Rather that's 0, 25, 50, 75, 100
CrazyHeliDude 2 months ago
thanks for the video!
there's a bit of a confusion about the battery installation. the manual says to push it all the way into the holder.
im a bloody beginner and didn't fly yet, so i have no experience how the helicopter should be balanced. can anybody please help me with this?
kingdakapu 3 months ago
@kingdakapu - The manual is correct, just push it all the way to the hilt. It should be balanced properly at that point.
CrazyHeliDude 2 months ago