i just did the clutch on my cr 125. but when i put the pressure plate on i did push it in like you said. then i put all the springs on and finished it, but when i went up to the clutch and pulled it in it felt free. why is that?
my bike slowley creeps foward and have to give it a lot of gas to get going. when i stop i have to use one of my brakes to the fullest power and hold about half throttle to keep it going. i thank its my clutch. what should i do ive thought about changeing my plates and basket but that alone is $230 OR IS IT SOMETHING AS SIMPLE AS SPRINGS. please help
what years the bike ? I didnt even notice if it was a 250 which takes a judder spring..would REALLY HELP to explain what makes the two ODDBALL frictions must be obvious since no description of the difference
all great info. but you could have warped the pressure plate. the most simple part. put the bolts in evenly and take them out evenly. turn each bolt 4-5 tiimes and move the one across
i just did the clutch on my cr 125. but when i put the pressure plate on i did push it in like you said. then i put all the springs on and finished it, but when i went up to the clutch and pulled it in it felt free. why is that?
dh4life100 1 week ago
@eazycheezie i would think its the springs because if you have to give it gas while stopped that means your clutch is in a sense constantly grabbing
shortyjk95 3 weeks ago
my bike slowley creeps foward and have to give it a lot of gas to get going. when i stop i have to use one of my brakes to the fullest power and hold about half throttle to keep it going. i thank its my clutch. what should i do ive thought about changeing my plates and basket but that alone is $230 OR IS IT SOMETHING AS SIMPLE AS SPRINGS. please help
eazycheezie 1 month ago
hey wtf wont my kx125 shift
traysmashgangjr 1 month ago
@2:41 Thats wat she said
LaOxProdigY 2 months ago 2
my 2005 kawasaki kx250f slowly creeps forward when in first while i hold clutch in. what would that be. thanks
motoxcrazyness 3 months ago
what years the bike ? I didnt even notice if it was a 250 which takes a judder spring..would REALLY HELP to explain what makes the two ODDBALL frictions must be obvious since no description of the difference
286trucker 4 months ago
how much are clutches usually? i have a 2009 kx250f
Braaap341 4 months ago
all great info. but you could have warped the pressure plate. the most simple part. put the bolts in evenly and take them out evenly. turn each bolt 4-5 tiimes and move the one across
staticxmako 5 months ago
should i drain my oil before doing this?
mophead9615 5 months ago