Wilco 737 - FMC - Preflight and departure tutorial

Here's a tutorial of how to program the FMC of the 737 from Wilco. I will show you how to put a flightplan with airways into the system and other programming before you are ready for takeoff. I will also show how to select departure routes and runways.

European routes: http://www.euroutepro.com/fp/fp_main.php?site=pl&language=en
Worldwide routes: http://rfinder.asalink.net/free/

Sorry about bad spelling, grammar, etc..

Category:

Travel & Events

Tags:

• FMC
• Wilco
• boeing
• 737-300
• -400
• -500
• tutorial
• routes
• flightplan
• STAR
• SID
• SID/STAR

[zuludelta100]

Would I be right in saying your Gross weight was entered wrong, I could be wrong but I am sure you were meant to enter 112.2 instead of 122.2. Regards

[tasspus]

@zuludelta100 Well observed! Yes, you are fully correct. I will change it right now, thanks!

[StarTour747]

Hvilken flysimulator / program er det?

[tasspus]

@StarTour747 Her har jeg brukt FS2004, men FMC'en er helt lik som i FSX =)

[StarTour747]

@tasspus FSX har vel ikke en FMC? :)

[tasspus]

@StarTour747 FSX-versjonen av Wilco's 737 så ;)

[MegaAmarchana123]

THANK YOU THANK YOU THANK YOU SO SO SO SO SO SO MUCH U THE BEST!!!!!!!!!!!!

[alruin4531]

I took me a couple of years before I found out where the TO/GA switch was on this plane.. lol

[HEADBANGBALLER]

Great tutorial. I just got this and it's alot different than what I was used to. Much more interactive and realistic. My FMS reads "Database out of date". Is that normal or is there something else I need to do. Thanks again, it's people like you who make FSX enjoyable.

[MrStefanbergmann]

i keep getting not in database help?

[witnessdreamer]

@witnessdreamer thanks for the answer i ´m goig to try this solution and i will post you any fact !!

[VGN737]

@witnessdreamer Press the LNAV and switch on the autopilot :)

[briones1805]

Hello, Very interesting your tutorial. I have one question, please. During take off, I don't hear V1, VR signs. What could I do? Thanks!

[rewindablender]

@iwannalearnfly both

[iwannalearnfly]

is it for fsx or fs2004?

[davidc437]

Its good, but it's not put together very well, its much simpler to setup your RTE 1 page and go straight to DEP/ARR and set them both up, then fill in the waypoints, then starting with your performance details, you should also use VNAV not V/S. imho this tutorial jumps around too much. Disliked :|