Trick Shot Butterfly
Uploader Comments (jambneu)
All Comments (19)
-
@W16isrock even if you could, who would do this, it would cost so much to repair that any hustle you would do would not be worth it
-
your truely retarded if you think you can honestly put dents in a decent pool table like that... unless you baught a peice of shit table with wood under the felt instead of getting a decent one with slate, that isnt gonna do jack shit to your table
-
first of all, whoever falls for this obviously doesn't know anything about pool, because official pool tables are made of slate, which is a very heavy marble-like slab of stone that has been methodically cut and carved and then covered with a very thin(less than a millimeter) layer of tightly woven felt. If the pool table were to so much as chip, something that you would have a hard time doing with even a jack hammer, the felt would catch it. You can't dent, divot, or anything onto a pool table.
-
again, no it doesn't... Doing that wont make any kind of roll on the table, and if a ball goes over one of the divots, it will just go right over it, unless the ball is going very slowly, and if it is going really slowly then it wouldn't have gone any further anyway!
-
no it won't crack the table no shit but your table starts to roll off.
-
Now only if we knew the placement of the outer four balls
-
Look at some other tutorials... He wasn't showing you were to place them, he was showing you how to keep them in place and be able to make the shot over and over without looking like a dick. Good video in my opinion.. Also because I can actually do the butterfly
-
dude, it doesn't do any damage to the table... Slate is pretty strong and it wont crack just because it got hit a few times
-
Dude, you can't crack slate with a few pounds of the ball... dumbass
sorry what I am trying to show is how to set up your trick shots so that they will almost always go
jambneu 2 years ago