Savonius geared (vawt,vertical axis,windturbine,hawt, ametek)

http://www.farmenergyinc.ca http://www.wrapwind.com
100 watt in 25 to 35 kmh wind is possible.
this video will show the ratio testing.
it took many before it, i wasted many dollars to get to this point i hope you appreciate the effort i put into it.

i hope you enjoy this video and not shoot me down as much. think diffrent......
wind turbine generator Ametek renewable energy vawt hawt Vertical Savonius diy environment green roof power plans free controller batteries windturbine alternative efficiency efficient electric electricity grid homemade vertical axis goderich ontario wind turbine generator Ametek renewable energy vawt hawt Vertical Savonius diy environment green roof power plans free controller batteries windturbine alternative efficiency efficient grid homemade vertical axis goderich ontario
best regards
thanks

Category:

Science & Technology

Tags:

• rpm
• volts
• Watts
• bench
• test
• 3phase
• 24magnets
• 18coils
• 18awg
• star
• delta
• 12vdc
• 24vdc
• axial
• flux
• pma
• wind
• turbine
• generator
• Ametek
• renewable
• energy
• vawt
• hawt
• Vertical
• Savonius
• diy
• environment
• green
• roof
• power
• plans
• free
• controller
• batteries
• windturbine
• alternative
• efficiency
• efficient
• gridtie
• homemade
• axis
• goderich
• ontario
• climate
• change
• eco
• charge
• mppt
• ametek
• global
• nrg
• savonius
• off grid

[Mrinfoone]

Belts or chains slow it down a lot try gears which are better or try to attaching the motor on the bottom with the original shaft instead. which rotates better and without any lost in gearing as well. Two better ways to go than the belts and the noise that go with it.

[emagnets]

@Mrinfoone that is true, since then, i have been experimenting with direct drive only.

sam

[johnnnyreb51]

That's cool how the generator/motor thing starts turning BEFORE the gearing system.

[emagnets]

@johnnnyreb51, that was part of my beginig testing and seting up the pully correctly. the idea here is the setup ratio.

[waheex]

nice video. I am hoping to build a VAWT and was going to attach it directly to the motor. But after seeing your videos a pulley system would be a lot better. Where did you get you pulleys from ? thanks

[emagnets]

waheex, i bought the pullies from TSC stores.

the lift vawt is a better and more effecient system.

sam

[tom080955]

Lol...an honest instructional, well done. Every vid I've seen show mostly the blade and turbine structure, not the working, generator and gearing bits. Finally you may have started a trend. thanks!!

[thepvcbikeguy]

OK May be just a little cometary would be nice.

[TheJimmax]

thanks again sam you are a constant source of inspiration keep up the good work!

[emagnets]

@TheJimmax, it is funny when i look back at the begining..but i think i am on the right track now...this will show others that you can learn all kinds of tricks in few years!..

regards

sam